Samsung Galaxy Attain 4G Rear Housing Replacement Repair Guide

Difficulty

Moderate

Steps

7

Time Required

                          10 minutes            

Sections

2

• Battery
• 4 steps
• Rear Housing
• 3 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

Better Introduction

Improve this guide by completing or revising its introduction.

• BackSamsung Galaxy Attain 4G

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

What you need

Step 1

              Placement               

• Begin by turn the device over to it’s back, with the screen facing down.

Begin by turn the device over to it’s back, with the screen facing down.

1024

Step 2

              Battery Door Removal               

• At the top of the device there is a small notch that is used to remove the battery door.
• Using a pry tool or your fingernail, pry off the battery door from the main housing.

At the top of the device there is a small notch that is used to remove the battery door.

Using a pry tool or your fingernail, pry off the battery door from the main housing.

Step 3

              Battery Removal               

• Place the battery door to the side.
• Using a pry tool or your fingernail, pry the battery up towards you.
• You have now removed the battery!

Place the battery door to the side.

Using a pry tool or your fingernail, pry the battery up towards you.

You have now removed the battery!

Step 4

              Heads Up!               

• Make sure when replacing the battery that the arrow on the bottom is facing down.

Make sure when replacing the battery that the arrow on the bottom is facing down.

Step 5

              Screw Removal               

• Remove the 6 Phillips head screws that hold the rear housing in place.

Remove the 6 Phillips head screws that hold the rear housing in place.

Step 6

              Prying               

• Using a spudger or plastic pry tool, slowly go around the phone between the display & rear housing to release the clips.

Using a spudger or plastic pry tool, slowly go around the phone between the display & rear housing to release the clips.

Step 7

              Remove Housing               

• Lift the rear housing from the display assembly.

Lift the rear housing from the display assembly.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      4 other people completed this guide.                                             

Author

                                      with 2 other contributors 

                    Josh Forester                     

Member since: 11/28/2010

2,461 Reputation

                                      10 Guides authored                  



                       Badges:
                       31







                                                        +28 more badges