Difficulty

Moderate

Steps

10

Time Required

                          15 minutes

Sections

3

  • Screen
  • 3 steps
  • Motherboard
  • 4 steps
  • Camera
  • 3 steps

Flags

0

  • BackSamsung Galaxy J3 Emerge

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Screen
  • Heat up the edges of the screen with a hair dryer.
  • Put the iFixit Opening Tool between the screen and body to open the edge of the screen up.
  • Work the iFixit Opening Tools around the whole screen to break the glue.

Heat up the edges of the screen with a hair dryer.

Put the iFixit Opening Tool between the screen and body to open the edge of the screen up.

Work the iFixit Opening Tools around the whole screen to break the glue.

1024

Step 2

  • Lift the screen up from the bottom.
  • The screen could crack when lifting it up.
  • Pry the gray cover open.

Lift the screen up from the bottom.

The screen could crack when lifting it up.

Pry the gray cover open.

Step 3

  • Pry the connector off of the motherboard by using a clean nail or the iFixit opening tool.

Pry the connector off of the motherboard by using a clean nail or the iFixit opening tool.

Step 4

              Motherboard
  • Remove the eleven Phillips #00 3.5mm screws.
  • If the screws get stuck when removing, try using tape to get them out. Place the adhesive side of tape on the screws and pull the tape off the spot.

Remove the eleven Phillips #00 3.5mm screws.

If the screws get stuck when removing, try using tape to get them out. Place the adhesive side of tape on the screws and pull the tape off the spot.

Step 5

  • Turn the phone over and push down where the battery was.
  • There will be a loud clicking noise when applying pressure.

Turn the phone over and push down where the battery was.

There will be a loud clicking noise when applying pressure.

Step 6

  • Insert the iFixit Opening Pick between the motherboard and the panel.
  • Work the iFixit Opening Pick around the outside of the motherboard.

Insert the iFixit Opening Pick between the motherboard and the panel.

Work the iFixit Opening Pick around the outside of the motherboard.

Step 7

  • Pry the motherboard away from the phone using your hand.

Pry the motherboard away from the phone using your hand.

Step 8

              Camera
  • Pull the green tape over the connectors off.

Pull the green tape over the connectors off.

Step 9

  • Lift up the tabs to reveal the ribbons.

Lift up the tabs to reveal the ribbons.

Step 10

  • Pull the two camera ribbons away from the connectors.

Pull the two camera ribbons away from the connectors.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Hugh Cosculluela

Member since: 01/24/2019

507 Reputation

                                      4 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       Cal Poly, Team S19-G2, White Winter 2019                        

                                                  Member of Cal Poly, Team S19-G2, White Winter 2019 



                    CPSU-WHITE-W19S19G2                     


                                            4 Members                     


                                            5 Guides authored