Difficulty

Moderate

Steps

8

Time Required

                          10 - 15 minutes

Sections

3

  • Front Camera
  • 4 steps
  • Motherboard
  • 3 steps
  • Back Camera
  • 1 step

Flags

0

  • BackSamsung Galaxy J3V

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Front Camera
  • Place your thumb on the top left corner and pry the tab open and lift off the back cover.

Place your thumb on the top left corner and pry the tab open and lift off the back cover.

1024

Step 2

  • Remove the ten 2.0 mm screws with the Phillips #J000 screwdriver.

Remove the ten 2.0 mm screws with the Phillips #J000 screwdriver.

Step 3

  • Use a small suction cup to pull the screen up. Then slip a small plastic opening tool under the screen to pry it upwards.
  • If this is the first time the screen is being removed then there will be adhesive around the edges of the screen. It may be difficult to remove the screen because of this adhesive seal and it is going to take a few tries and some force to pry the entire screen off.

Use a small suction cup to pull the screen up. Then slip a small plastic opening tool under the screen to pry it upwards.

If this is the first time the screen is being removed then there will be adhesive around the edges of the screen. It may be difficult to remove the screen because of this adhesive seal and it is going to take a few tries and some force to pry the entire screen off.

Step 4

  • Use tweezers to flip tab of the front camera to remove it.

Use tweezers to flip tab of the front camera to remove it.

Step 5

              Motherboard
  • Remove connector tab with spudger then carefully remove headphone jack with tweezers.

Remove connector tab with spudger then carefully remove headphone jack with tweezers.

Step 6

  • Remove these connectors from the motherboard with spudger.

Remove these connectors from the motherboard with spudger.

Step 7

  • Carefully use the spudger to pry the motherboard out of the plastic tabs.

Carefully use the spudger to pry the motherboard out of the plastic tabs.

Step 8

              Back Camera
  • After removing the motherboard, locate and flip tab holding the rear camera’s connector.
  • Carefully use the tweezer to remove the connector and the camera.

After removing the motherboard, locate and flip tab holding the rear camera’s connector.

Carefully use the tweezer to remove the connector and the camera.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors 


                    Carry Corrales

Member since: 09/28/2017

738 Reputation

                                      5 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       USF Tampa, Team S3-G3, Nance Fall 2017                        

                                                  Member of USF Tampa, Team S3-G3, Nance Fall 2017 



                    USFT-NANCE-F17S3G3                     


                                            4 Members                     


                                            5 Guides authored

Harrington Kenneth - Apr 24, 2019

Reply

Your &&^&^$^ trash and did not help me at all.