Samsung Galaxy Mega 2 Front Facing Camera Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          15 minutes

Sections

Front Facing Camera
5 steps

Flags

BackSamsung Galaxy Mega 2
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Front Facing Camera

Before beginning, make sure phone is turned off.
On the back of the phone, find the slot at the charging port located at the bottom of the phone.
Either insert the plastic opening tool or use your fingernail to pull up on the back cover.
Once the corner is released, slide your finger around the outside until the back cover releases.

Before beginning, make sure phone is turned off.

On the back of the phone, find the slot at the charging port located at the bottom of the phone.

Either insert the plastic opening tool or use your fingernail to pull up on the back cover.

Once the corner is released, slide your finger around the outside until the back cover releases.

1024

Step 2

Locate the battery.
Use pry tool or fingernail to lift up on the battery.
Remove the battery.

Locate the battery.

Use pry tool or fingernail to lift up on the battery.

Remove the battery.

Step 3

Use phillips head PH000 and remove all 13, 1.4 mm screws as shown.
Using the pry tool, carefully pop the Digitizer cover off the device.
Use tweezers to disconnect the digitizer.

Use phillips head PH000 and remove all 13, 1.4 mm screws as shown.

Using the pry tool, carefully pop the Digitizer cover off the device.

Use tweezers to disconnect the digitizer.

Step 4

Insert the pry tool along the side of the device, then work your way around the borders of the screen, separating the screen from the rear assembling frame.
Remember once the screen is off, completely remove it from the mid-frame.
To remove the mid-frame from the motherboard, press down on the top right corner of the frame and the mid-frame should release from the motherboard.
When it releases use tweezers to pick up on the mid-frame to completely separate it from the motherboard.

Insert the pry tool along the side of the device, then work your way around the borders of the screen, separating the screen from the rear assembling frame.

Remember once the screen is off, completely remove it from the mid-frame.

To remove the mid-frame from the motherboard, press down on the top right corner of the frame and the mid-frame should release from the motherboard.

When it releases use tweezers to pick up on the mid-frame to completely separate it from the motherboard.

Step 5

Locate the camera in the top left corner.
Lift the motherboard connector and remove the camera assembly from phone.

Locate the camera in the top left corner.

Lift the motherboard connector and remove the camera assembly from phone.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 5 other contributors

                    Taylor Powell

Member since: 09/08/2017

699 Reputation

                                      5 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       Western Carolina University, Team S1-G6, Virtue Fall 2017                        

                                                  Member of Western Carolina University, Team S1-G6, Virtue Fall 2017 



                    WCU-VIRTUE-F17S1G6                     


                                            4 Members                     


                                            5 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team