Samsung Galaxy Mega 2 Screen Digitizer Assembly Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          15 minutes

Sections

Screen & Digitizer Assembly
5 steps

Flags

BackSamsung Galaxy Mega 2
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Screen & Digitizer Assembly

Before beginning, make sure the phone is turned off.
On the back of the phone, find the slot at the charging port located at the bottom of the phone.
Either insert the plastic opening tool or use your fingernail to pull up on the back cover.
Once the corner is released, slide your finger around the outside until the back cover releases.

Before beginning, make sure the phone is turned off.

On the back of the phone, find the slot at the charging port located at the bottom of the phone.

Either insert the plastic opening tool or use your fingernail to pull up on the back cover.

Once the corner is released, slide your finger around the outside until the back cover releases.

1024

Step 2

Locate the battery.
Insert fingernail or plastic opening tool into the slot on the bottom of the battery and gently lift up.
Remove the battery.

Locate the battery.

Insert fingernail or plastic opening tool into the slot on the bottom of the battery and gently lift up.

Remove the battery.

Step 3

Use a phillips head PH000 and remove all 13, 1.4 mm visible screws.
Using the pry tool, carefully pop the Digitizer cover off the device.
Use the pry tool to disconnect the digitizer

Use a phillips head PH000 and remove all 13, 1.4 mm visible screws.

Using the pry tool, carefully pop the Digitizer cover off the device.

Use the pry tool to disconnect the digitizer

Step 4

Insert the pry tool along the side of the device, then work your way around the borders of the screen, separating the screen from the rear assembly frame.
Be careful and do not lift the screen completely off yet, leave the screen at an angle.
Use the heat gun to heat up the bottom to loosen the adhesive from the menu and back buttons.
Once heated, gently pull the screen upward.
Make sure that the buttons are separating from the adhesive.

Insert the pry tool along the side of the device, then work your way around the borders of the screen, separating the screen from the rear assembly frame.

Be careful and do not lift the screen completely off yet, leave the screen at an angle.

Use the heat gun to heat up the bottom to loosen the adhesive from the menu and back buttons.

Once heated, gently pull the screen upward.

Make sure that the buttons are separating from the adhesive.

Step 5

Now, seperate the screen from the outside frame of the phone (the bezel).

Now, seperate the screen from the outside frame of the phone (the bezel).

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 3 other contributors

                    Taylor Powell

Member since: 09/08/2017

699 Reputation

                                      5 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       Western Carolina University, Team S1-G6, Virtue Fall 2017                        

                                                  Member of Western Carolina University, Team S1-G6, Virtue Fall 2017 



                    WCU-VIRTUE-F17S1G6                     


                                            4 Members                     


                                            5 Guides authored

Monirul Islam - Apr 24, 2019

I want to repair my phone

Introduction#

What you need#

Team#

Introduction

What you need

Team