Difficulty
Easy
Steps
6
Time Required
5 seconds - 45 minutes
Sections
1
- Front Display Assembly
- 6 steps
Flags
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackSamsung Galaxy Mega
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
If you don’t know what we are doing from reading the title, I’m afraid your a little in over your head.
As for the rest of us, lace up and lets get ready for some football. By football I mean prepare to break down the Galaxy Mega front LCD Assembly and replace it with a better looking one.
What you need
Video Overview
Step 1
Remove battery and rear door.
- bold textWith a heavily shattered screen lay some tape over it to protect yourself and to keep it all in one place.
- Flip the phone over to remove the batter door and battery.
bold textWith a heavily shattered screen lay some tape over it to protect yourself and to keep it all in one place.
Flip the phone over to remove the batter door and battery.
1024
Step 2
Remove Phillips Screws and Speaker componant.
- With a phillips remove all 14 visibile screws.
- Using your pry tool slowly pop the speaker companant off.being careful not to damage it
With a phillips remove all 14 visibile screws.
Using your pry tool slowly pop the speaker companant off.being careful not to damage it
Step 3
Remove rear assembly frame
- Using the pry tool work your way arounf the phone, separating the rear assembly frame from the device.
- the frame can be deceiving and seem as if it attached closer to the top but in the picture you will see down to the middle is where you should look to separate.
- Fully remove the rear assembly frame from the main device.
Using the pry tool work your way arounf the phone, separating the rear assembly frame from the device.
the frame can be deceiving and seem as if it attached closer to the top but in the picture you will see down to the middle is where you should look to separate.
Fully remove the rear assembly frame from the main device.
Step 4
Remove the LCD Cable and the Front Camera
- Using a spudger or pry tool lift remove the LCD flex cable from the logic board.
- Next with a phillips screwdriver remove the one screw holding the protection plate over the cameras,
- Proceed to remove the front camera
Using a spudger or pry tool lift remove the LCD flex cable from the logic board.
Next with a phillips screwdriver remove the one screw holding the protection plate over the cameras,
Proceed to remove the front camera
Step 5
Using heat to soften the adhesive
- With your heat hun slowly heat the screen while using pry tool to work your wau around the device.
- With atleast 3 guitar pick keeping separation as you progress the screen should slowly start lifting off.
- leave the bottom area for last and be careful with your tools to not damage the back cable.
With your heat hun slowly heat the screen while using pry tool to work your wau around the device.
With atleast 3 guitar pick keeping separation as you progress the screen should slowly start lifting off.
leave the bottom area for last and be careful with your tools to not damage the back cable.
Step 6
Remove bad LCD
- Clean device then follow the steps in reverse.
Clean device then follow the steps in reverse.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
4 other people completed this guide.
Author
with 1 other contributor
Austin Pollard
Member since: 02/05/2017
1,402 Reputation
3 Guides authored
Badges:
14
+11 more badges
Team
Reno Phone Repair
Member of Reno Phone Repair
Business
1 Member
6 Guides authored