Difficulty

Easy

Steps

10

Time Required

                          15 - 20 minutes            

Sections

3

  • Back Cover
  • 3 steps
  • Battery
  • 3 steps
  • Headphone Jack
  • 4 steps

Flags

1

This guide has been the hard work of our awesome students and is found to be exceptionally cool by the iFixit staff.

  • BackSamsung Galaxy Note 8.0 Tablet (2013)

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Cover               
  • Remove the Samsung S-Pen stylus.
  • Remove the micro SD storage card.

Remove the Samsung S-Pen stylus.

Remove the micro SD storage card.

1024

Step 2

  • Using the plastic opening tool, start where the S-pen was located and carefully pry up the corner.

Using the plastic opening tool, start where the S-pen was located and carefully pry up the corner.

Step 3

  • Work your way around the entire device by carefully prying and sliding the plastic opening tool.
  • There are clips approximately 2cm apart. As you are removing the back cover you should hear the clips being dislocated from the tablet.

Work your way around the entire device by carefully prying and sliding the plastic opening tool.

There are clips approximately 2cm apart. As you are removing the back cover you should hear the clips being dislocated from the tablet.

Step 4

              Battery               
  • Remove the 8 Phillips#00 3-mm screws holding the battery in place.

Remove the 8 Phillips#00 3-mm screws holding the battery in place.

Step 5

  • Lift the top left corner of the battery up by the black tab.

Lift the top left corner of the battery up by the black tab.

Step 6

  • Gently grasp and lift up the white connector located at the bottom right corner of the battery. It is connected to the battery by two blue and two red wires.
  • Do not yank the connector by the wires. If it does not disconnect easily, slide a plastic opening tool between the white connector and the board to lift the connector away from the board.

Gently grasp and lift up the white connector located at the bottom right corner of the battery. It is connected to the battery by two blue and two red wires.

Do not yank the connector by the wires. If it does not disconnect easily, slide a plastic opening tool between the white connector and the board to lift the connector away from the board.

Step 7

              Headphone Jack               
  • Remove the two 4.5-mm black phillips head screws using a #00Phillips screwdriver.

Remove the two 4.5-mm black phillips head screws using a #00Phillips screwdriver.

Step 8

  • Gently pry up the teal connector.
  • Do not yank the connector. If it does not disconnect easily use a plastic opening tool between the connector and the board to lift the connector away from the board.

Gently pry up the teal connector.

Do not yank the connector. If it does not disconnect easily use a plastic opening tool between the connector and the board to lift the connector away from the board.

Step 9

  • Gently pry up the gold connector.
  • Do not yank the connector. If it does not disconnect easily use a plastic opening tool between the connector and the board to lift the connector away from the board.

Gently pry up the gold connector.

Step 10

  • Remove the headphone jack from it’s housing.
  • If difficult, use a plastic opening tool to pry up.

Remove the headphone jack from it’s housing.

If difficult, use a plastic opening tool to pry up.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      6 other people completed this guide.                                             

Author

                                      with 4 other contributors 

                    Joel                     

Member since: 09/23/2014

1,856 Reputation

                                      6 Guides authored                  



                       Badges:
                       20







                                                        +17 more badges                           

Team

                       USF Tampa, Team 12-2, Blackwell Fall 2014                        

                                                  Member of USF Tampa, Team 12-2, Blackwell Fall 2014 



                    USFT-BLACKWELL-F14S12G2                     


                                            4 Members                     


                                            16 Guides authored                     

Shasta - Aug 17, 2017

Reply

Lightning struck while my son was on his tablet… no more headset audio? Replaced recommend parts still no audio. Plays fine without earbuds??? Insurance claim? What else could be the issue? Motherboard?

sanco - Apr 16, 2019

Reply

what are these connectors on the left side of headphone jack which are connected to the backside plate?