Difficulty
Easy
Steps
9
Time Required
30 minutes
Sections
3
- Back Cover
- 3 steps
- Battery
- 3 steps
- Speakers
- 3 steps
Flags
0
BackSamsung Galaxy Note 8.0 Tablet (2013)
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Cover
- Remove the Samsung S-Pen stylus.
- Remove the micro SD storage card.
Remove the Samsung S-Pen stylus.
Remove the micro SD storage card.
1024
Step 2
- Using the plastic opening tool, start where the S-pen was located and carefully pry up the corner.
Using the plastic opening tool, start where the S-pen was located and carefully pry up the corner.
Step 3
- Work your way around the entire device by carefully prying and sliding the plastic opening tool.
- There are clips approximately 2cm apart. As you are removing the back cover you should hear the clips being dislocated from the tablet.
Work your way around the entire device by carefully prying and sliding the plastic opening tool.
There are clips approximately 2cm apart. As you are removing the back cover you should hear the clips being dislocated from the tablet.
Step 4
Battery
- Remove the 8 Phillips#00 3-mm screws holding the battery in place.
Remove the 8 Phillips#00 3-mm screws holding the battery in place.
Step 5
- Lift the top left corner of the battery up by the black tab.
Lift the top left corner of the battery up by the black tab.
Step 6
- Gently grasp and lift up the white connector located at the bottom right corner of the battery. It is connected to the battery by two blue and two red wires.
- Do not yank the connector by the wires. If it does not disconnect easily, slide a plastic opening tool between the white connector and the board to lift the connector away from the board.
Gently grasp and lift up the white connector located at the bottom right corner of the battery. It is connected to the battery by two blue and two red wires.
Do not yank the connector by the wires. If it does not disconnect easily, slide a plastic opening tool between the white connector and the board to lift the connector away from the board.
Step 7
Speakers
- Gently pry up the connectors there is one per speaker
- Do not yank the connector. If it does not disconnect easily use a plastic opening tool between the connector and the board to lift the connector away from the board.
Gently pry up the connectors there is one per speaker
Do not yank the connector. If it does not disconnect easily use a plastic opening tool between the connector and the board to lift the connector away from the board.
Step 8
- For each speaker remove the two 3-mm Phillips head screws using a Phillips #00 screwdriver.
For each speaker remove the two 3-mm Phillips head screws using a Phillips #00 screwdriver.
Step 9
- Remove the speakers from their housing.
- If difficult use a plastic opening tool to pry up.
Remove the speakers from their housing.
If difficult use a plastic opening tool to pry up.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
4 other people completed this guide.
Author
with 5 other contributors
Joel
Member since: 09/23/2014
1,856 Reputation
6 Guides authored
Badges:
20
+17 more badges
Team
USF Tampa, Team 12-2, Blackwell Fall 2014
Member of USF Tampa, Team 12-2, Blackwell Fall 2014
USFT-BLACKWELL-F14S12G2
4 Members
16 Guides authored
