Samsung Galaxy Pocket Neo S5310 Lcd Display Touch Screen Replacement Repair Guide

Difficulty

Difficult

Steps

8

Time Required

                          25 - 35 minutes            

Sections

3

• Loudspeaker
• 2 steps
• Logic Board
• 1 step
• Touchscreen, Digitizer Glass, LCD Display
• 5 steps

Flags

1

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

• BackSamsung Galaxy Pocket Neo S5310

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

Vedeo manual:

What you need

Video Overview

Step 1

              Loudspeaker               

• Remove any SIM and SD card.
• Remove 7x Phillips screws.
• Use a plastic tool to disassemble the rear housing.

Remove any SIM and SD card.

Remove 7x Phillips screws.

Use a plastic tool to disassemble the rear housing.

1024

Step 2

• The Loudspeaker is located on the rear housing..

The Loudspeaker is located on the rear housing..

Step 3

              Logic Board               

• Disconnect the LCD Display flex cable.
• Lift up the board and disconnect the Touchscreen flex cable.
• Now you can remove the Motherboard.

Disconnect the LCD Display flex cable.

Lift up the board and disconnect the Touchscreen flex cable.

Now you can remove the Motherboard.

Step 4

              Touchscreen, Digitizer Glass, LCD Display               

• Warm the touchscreen to make separating the LCD Display more easy
• For this manipulation you can use a hair drier.
• In the four corners of LCD display there are small metal plates. Use one of them to lift a little the LCD and put the plastic tool.
• Be careful not to break the display.

Warm the touchscreen to make separating the LCD Display more easy

For this manipulation you can use a hair drier.

In the four corners of LCD display there are small metal plates. Use one of them to lift a little the LCD and put the plastic tool.

Be careful not to break the display.

Step 5

• After separating the LCD Display, again worm the Touchscreen.
• If the glass is broken, put a transparent tape to prevent scattering.

After separating the LCD Display, again worm the Touchscreen.

If the glass is broken, put a transparent tape to prevent scattering.

Step 6

• Use plastic tools and slowly separate the touch screen from the front bezel.

Use plastic tools and slowly separate the touch screen from the front bezel.

Step 7

• If the new spare part has come without adhesive tape. you must put.
• Reassemble your device, follow these instructions in reverse order.

If the new spare part has come without adhesive tape. you must put.

Reassemble your device, follow these instructions in reverse order.

Step 8

• Did you do it successfully?

Did you do it successfully?

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.                                             

Author

                    ZFix                     

Member since: 12/09/2013

187,195 Reputation

                                      330 Guides authored                  



                       Badges:
                       35







                                                        +32 more badges                           

Team

                       Master Techs                        

                                                  Member of Master Techs 



                    Community                     


                                            310 Members                     


                                            1,168 Guides authored