Samsung Galaxy Prevail Volume Camera Power Buttons Replacement Repair Guide

Difficulty

Moderate

Steps

6

Time Required

                          15 - 30 minutes            

Sections

1

• Volume, Camera, & Power Buttons
• 6 steps

Flags

2

Missed a Step

Oops! This guide is currently missing some important steps.

Slice and Dice

The steps in this guide should be split up and made into a series of prerequisite guides.

• BackSamsung Galaxy Prevail

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Volume, Camera, & Power Buttons               

• Using your hands, carefully remove the back panel by popping the open slit, near the headphone jack, outwards.

Using your hands, carefully remove the back panel by popping the open slit, near the headphone jack, outwards.

1024

Step 2

• Using your fingernail or nylon spudger, remove the battery by lifting upward in the recess of the bottom right corner.

Using your fingernail or nylon spudger, remove the battery by lifting upward in the recess of the bottom right corner.

Step 3

• Remove the (6) 4mm screws using a Phillips #00 screwdriver.

Remove the (6) 4mm screws using a Phillips #00 screwdriver.

Step 4

• Using the black spudger, carefully unhinge and pry the secondary rear panel using the recessed tabs on the left and right sides.
• The secondary rear panel houses the camera lens and speaker assembly,
• The metal trim of the headphone jack may come loose during this process.

Using the black spudger, carefully unhinge and pry the secondary rear panel using the recessed tabs on the left and right sides.

The secondary rear panel houses the camera lens and speaker assembly,

The metal trim of the headphone jack may come loose during this process.

Step 5

• Using the spudger, gently pry upward on the motherboard by the right side.
• Motherboard is connected to shield plate with ribbon cable.

Using the spudger, gently pry upward on the motherboard by the right side.

Motherboard is connected to shield plate with ribbon cable.

Step 6

• Remove the desired button by pushing inward with the spudger or disconnecting the rubber pin connections.

Remove the desired button by pushing inward with the spudger or disconnecting the rubber pin connections.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 

                    Ricardo Zuloaga                     

Member since: 09/15/2016

525 Reputation

                                      5 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges                           

Team

                       USF Tampa, Team 17-6, Blackwell Fall 2016                        

                                                  Member of USF Tampa, Team 17-6, Blackwell Fall 2016 



                    USFT-BLACKWELL-F16S17G6                     


                                            3 Members                     


                                            5 Guides authored