Difficulty

Moderate

Steps

7

Time Required

                          5 minutes

Sections

3

  • Battery
  • 2 steps
  • Midframe
  • 4 steps
  • Unhooking Antenna Cable
  • 1 step

Flags

0

  • BackSamsung Galaxy S Vibrant

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Locate the small slit on the bottom edge of the device between the back and front cases.
  • Pop the back case off by inserting your finger and pulling the case away from the phone.
  • If necessary (it shouldn’t be), use the Plastic Opening Tools to pry the back case off.

Locate the small slit on the bottom edge of the device between the back and front cases.

Pop the back case off by inserting your finger and pulling the case away from the phone.

If necessary (it shouldn’t be), use the Plastic Opening Tools to pry the back case off.

1024

Step 2

  • Remove the battery by pushing the bottom edge of the battery up and away from the phone
  • If you would prefer, you may use the Plastic Opening Tools for this step as well.

Remove the battery by pushing the bottom edge of the battery up and away from the phone

If you would prefer, you may use the Plastic Opening Tools for this step as well.

Step 3

              Midframe
  • Remove SIM card by pushing down and away from the slot, then pulling it out toward the bottom edge of the phone.

Remove SIM card by pushing down and away from the slot, then pulling it out toward the bottom edge of the phone.

Step 4

  • Remove the seven 4.5 mm Phillips #00 screws along the perimeter of the phone.

Remove the seven 4.5 mm Phillips #00 screws along the perimeter of the phone.

Step 5

  • Staring near the power button, use a plastic opening tool to disengage the plastic clips securing the midframe.
  • Work carefully, and disengage all of the clips before removing the midframe.
  • The power button and the volume control button on the sides of the phone will fall out when the midframe is removed.

Staring near the power button, use a plastic opening tool to disengage the plastic clips securing the midframe.

Work carefully, and disengage all of the clips before removing the midframe.

The power button and the volume control button on the sides of the phone will fall out when the midframe is removed.

Step 6

  • Slide the SD card out of its slot.

Slide the SD card out of its slot.

Step 7

              Unhooking Antenna Cable
  • Disconnect the antenna using Tweezers. Do the lower end first, and then the upper.
  • Do the lower end first, and then the upper.
  • Pull the antenna cable out.

Disconnect the antenna using Tweezers. Do the lower end first, and then the upper.

Do the lower end first, and then the upper.

Pull the antenna cable out.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 6 other contributors 


                    Taylor Catlin

Member since: 01/15/2013

79 Reputation

                                      6 Guides authored                  



                       Badges:
                       14







                                                        +11 more badges

Team

                       Cal Poly, Team 18-37, Regan Winter 2013                        

                                                  Member of Cal Poly, Team 18-37, Regan Winter 2013 



                    CPSU-REGAN-W13S18G37                     


                                            4 Members                     


                                            8 Guides authored