Samsung Galaxy Tab A 2019 Usb C Charging Port Replacement Repair Guide

Difficulty

Moderate

Steps

4

Time Required

                          1 hour            

Sections

1

• USB-C Charging port
• 4 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

• BackSamsung Galaxy Tab A 10.1 (2019)

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Remove the display               

• As mentioned before, display is glued in. Heating it up to soften the glue is recommended. You can use dedicated heat plate, hair dryer, heat gun on low power or 3D printers heated bed.I went for the last option, because of even heat distribution and regulated temperature - set to 60 C.
• When display is heated up, insert a prying tool between the display and case perimeter - top part is recommended to start as it prevents damaging screen PCB located at the bottom.
• Using suction cups will make the removal much easier.
• Move the prying tool around to cut all of the glue.
• Unplug the display flex cable and remove the display.

As mentioned before, display is glued in. Heating it up to soften the glue is recommended. You can use dedicated heat plate, hair dryer, heat gun on low power or 3D printers heated bed.I went for the last option, because of even heat distribution and regulated temperature - set to 60 C.

When display is heated up, insert a prying tool between the display and case perimeter - top part is recommended to start as it prevents damaging screen PCB located at the bottom.

Using suction cups will make the removal much easier.

Move the prying tool around to cut all of the glue.

Unplug the display flex cable and remove the display.

1024

Step 2

              Open the outer case               

• Remove all philips-head screws from around the perimeter.
• Use a prying tool to disconnect two parts of the case.

Remove all philips-head screws from around the perimeter.

Use a prying tool to disconnect two parts of the case.

Step 3

              Remove the charging port               

• Now you can see the PCB with the charging port.
• Disconnect three flex cables.
• Use a prying tool or a small flat-head screwdriver to remove the PCB.

Now you can see the PCB with the charging port.

Disconnect three flex cables.

Use a prying tool or a small flat-head screwdriver to remove the PCB.

Step 4

              Tests               

• Install a new charging port.
• Test if device is charging properly.

Install a new charging port.

Test if device is charging properly.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.                                             

Author

                                      with 1 other contributor 

                    Magnetik                     

Member since: 06/22/2022

169 Reputation

                                      1 Guide authored                  



                       Badges:
                       5







                                                        +2 more badges