Samsung Galaxy Tab A 9 7 Display Replacement Repair Guide

Difficulty

Moderate

Steps

8

Time Required

                          10 minutes            

Sections

3

• Back Cover
• 1 step
• Battery
• 4 steps
• Display
• 3 steps

Flags

0

• BackSamsung Galaxy Tab A 9.7

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

You will want to work on a clean and flat table where you will easily be able to locate all parts and tools.

What you need

Step 1

              Back Cover               

• Insert a metal spudger between the back case and the screen of the device.
• The back cover is attached to the device by a series of snaps. The snaps are positioned about an inch from each other.
• Move the spudger along the perimeter of the device while it is in between the back case and the screen to open each snap.
• There will be an audible click every time a snap releases.

Insert a metal spudger between the back case and the screen of the device.

The back cover is attached to the device by a series of snaps. The snaps are positioned about an inch from each other.

Move the spudger along the perimeter of the device while it is in between the back case and the screen to open each snap.

There will be an audible click every time a snap releases.

1024

Step 2

              Battery               

• Remove the eleven #000 Phillips 2.8mm screws that hold the battery in place.

Remove the eleven #000 Phillips 2.8mm screws that hold the battery in place.

Step 3

• Place one hand on the battery and grasp the outer edge of the device with the other hand.
• Flip the device over so that the battery falls over and onto your hand.

Place one hand on the battery and grasp the outer edge of the device with the other hand.

Flip the device over so that the battery falls over and onto your hand.

Step 4

• Pull the battery out until it is only connected to the device by the black, yellow, and red connectors.

Pull the battery out until it is only connected to the device by the black, yellow, and red connectors.

Step 5

• Hold the battery and grip the wires with your thumb and finger.
• Pull the wires away from the device to remove the white connector from the black socket.
• Lift the battery away from the device.

Hold the battery and grip the wires with your thumb and finger.

Pull the wires away from the device to remove the white connector from the black socket.

Lift the battery away from the device.

Step 6

              Display               

• Gently remove the tape covering the screen ribbon cable, located at the top of the devise.
• With the plastic spudger, disconnect the ribbon cable from the motherboard, located at the middle of the device.

Gently remove the tape covering the screen ribbon cable, located at the top of the devise.

With the plastic spudger, disconnect the ribbon cable from the motherboard, located at the middle of the device.

Step 7

• Using a plastic spudger, work around the edge of the screen, prying the screen away from the device.

Using a plastic spudger, work around the edge of the screen, prying the screen away from the device.

Step 8

• Use the left side of the tablet as a hinge to swing the display assembly open.
• As you move the display assembly, make sure that the display ribbon cable is unattached.

Use the left side of the tablet as a hinge to swing the display assembly open.

As you move the display assembly, make sure that the display ribbon cable is unattached.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.                                             

Author

                                      with 2 other contributors 

                    Jakob Gerald Schumacher                     

Member since: 02/20/2020

292 Reputation

                                      3 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges                           

Team

                       The Citadel Military College of South Carolina, Team S2-G13, Eggleston Spring 2020                        

                                                  Member of The Citadel Military College of South Carolina, Team S2-G13, Eggleston Spring 2020 



                    CMCSC-EGGLESTON-S20S2G13                     


                                            2 Members                     


                                            3 Guides authored                     

HetBesteNaam - Aug 24, 2020

Reply

my device burnt down.