Difficulty
Moderate
Steps
10
Time Required
15 - 20 minutes
Sections
3
- Rear Case
- 2 steps
- Motherboard
- 6 steps
- Camera
- 2 steps
Flags
0
BackSamsung Galaxy Tab E Lite 7 Kids
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Rear Case
- Make sure the device is turned off before attempting to disassemble it.
- Using a plastic opening tool, wedge in the seam between the screen and the case.
- Rock the tool by moving it towards and away from the middle of the screen, trying to separate the tape holding the screen and case together.
Make sure the device is turned off before attempting to disassemble it.
Using a plastic opening tool, wedge in the seam between the screen and the case.
Rock the tool by moving it towards and away from the middle of the screen, trying to separate the tape holding the screen and case together.
1024
Step 2
- After separating the latches holding the screen and case together, slowly take the screen off the case.
After separating the latches holding the screen and case together, slowly take the screen off the case.
Step 3
Motherboard
- Use the plastic opening tool to lift up the black ZIF (zero insertion force) connector.
- Use your hands to pull the black cable out of its slot.
Use the plastic opening tool to lift up the black ZIF (zero insertion force) connector.
Use your hands to pull the black cable out of its slot.
Step 4
- Use the plastic opening tool to lift the ZIF (zero insertion force) connector holding the ribbon cable.
- Pull out the battery’s ribbon cable.
Use the plastic opening tool to lift the ZIF (zero insertion force) connector holding the ribbon cable.
Pull out the battery’s ribbon cable.
Step 5
- Use the plastic opening tool to lift up the latch to the ribbon cable.
- Remove the ribbon cable from the connector.
Use the plastic opening tool to lift up the latch to the ribbon cable.
Remove the ribbon cable from the connector.
Step 6
- Remove the seven 4mm PH000 screws holding the motherboard in place.
Remove the seven 4mm PH000 screws holding the motherboard in place.
Step 7
- Use the plastic opening tool to pry up the tab holding the motherboard in place.
Use the plastic opening tool to pry up the tab holding the motherboard in place.
Step 8
- Use the precision tweezers to remove the black plastic corner on top of the motherboard.
- Use the plastic opening tool to pull the motherboard out of the case.
Use the precision tweezers to remove the black plastic corner on top of the motherboard.
Use the plastic opening tool to pull the motherboard out of the case.
Step 9
Camera
- Flip the motherboard over.
- Use a plastic opening tool to lift up the latch holding the camera cable.
Flip the motherboard over.
Use a plastic opening tool to lift up the latch holding the camera cable.
Step 10
- Pull the ribbon cable and the camera.
Pull the ribbon cable and the camera.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Jordan Bermudez
Member since: 02/17/2017
285 Reputation
2 Guides authored
Badges:
7
+4 more badges
Team
USF Tampa, Team S19-G2, Hoffman Spring 2017
Member of USF Tampa, Team S19-G2, Hoffman Spring 2017
USFT-HOFFMAN-S17S19G2
4 Members
7 Guides authored
