Difficulty

Moderate

Steps

5

Time Required

                          10 minutes

Sections

2

  • Front half and Back half
  • 3 steps
  • Camera
  • 2 steps

Flags

1

This guide has been the hard work of our awesome students and is found to be exceptionally cool by the iFixit staff.

  • BackSamsung Gear 2

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Front half and Back half
  • Before disassembling your Gear, be sure it is powered off.
  • To remove each strap, locate the metal latches on both sides of the back of the Gear.
  • Press down on the metal latch while pulling the strap away from the Gear until it is completely off.

Before disassembling your Gear, be sure it is powered off.

To remove each strap, locate the metal latches on both sides of the back of the Gear.

Press down on the metal latch while pulling the strap away from the Gear until it is completely off.

1024

Step 2

  • Remove the four 4.0 mm screws on the back of the Gear using a T5 Torx Screwdriver.

Remove the four 4.0 mm screws on the back of the Gear using a T5 Torx Screwdriver.

Step 3

  • Firmly holding the Gear, insert the flat side of the spudger at an angle to pry the back casing off of the device. Move the spudger along the sides of the Gear to completely detach the back and front components.
  • Pry the device open from the other side also if it does not fully disassemble from one side.

Firmly holding the Gear, insert the flat side of the spudger at an angle to pry the back casing off of the device. Move the spudger along the sides of the Gear to completely detach the back and front components.

Pry the device open from the other side also if it does not fully disassemble from one side.

Step 4

              Camera
  • Locate the rectangular metal connector that attaches the camera to the Gear.
  • Use tweezers to gently lift and detach the metal plate of the connector.
  • When reassembling the Gear, reattach the camera connector by carefully aligning the metal plate and its pins to its original placement. Make sure it snaps in place to avoid improper connections and possible damage.

Locate the rectangular metal connector that attaches the camera to the Gear.

Use tweezers to gently lift and detach the metal plate of the connector.

When reassembling the Gear, reattach the camera connector by carefully aligning the metal plate and its pins to its original placement. Make sure it snaps in place to avoid improper connections and possible damage.

Step 5

  • Use tweezers to carefully lift the camera from its slot out of the case.

Use tweezers to carefully lift the camera from its slot out of the case.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 3 other contributors 


                    Allison Michel

Member since: 04/14/2014

513 Reputation

                                      3 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       Cal Poly, Team 13-27, Maness Spring 2014                        

                                                  Member of Cal Poly, Team 13-27, Maness Spring 2014 



                    CPSU-MANESS-S14S13G27                     


                                            4 Members                     


                                            6 Guides authored

jorge - Dec 10, 2014

Reply

Hey cool! Were can i buy the camara?