Samsung Gear Live Back Replacement Repair Guide

Difficulty

Easy

Steps

8

Time Required

                          1 minute            

Sections

2

• Watchband
• 3 steps
• Back
• 5 steps

Flags

1

Step Trimmer

This guide has unnecessary steps. Trim them to be more concise!

• BackSamsung Gear Live

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Lay the watch face-down               

• Lay the watch face-down on a flat, stable surface.

Lay the watch face-down on a flat, stable surface.

1024

Step 2

              Remove the holding pin               

• Press the watchband down against the work surface.
• Press the tip of a flathead screwdriver against the edge of the spring-loaded holding pin.

Press the watchband down against the work surface.

Press the tip of a flathead screwdriver against the edge of the spring-loaded holding pin.

Step 3

              Remove the watchband               

• With the spring-loaded pin pressed in, the watch band should release easily.
• Gently pull the band away from the body of the watch.
• Repeat steps 2 and 3 for the opposite side.

With the spring-loaded pin pressed in, the watch band should release easily.

Gently pull the band away from the body of the watch.

Repeat steps 2 and 3 for the opposite side.

Step 4

              Locate the four screws               

• With the watch laying face-down, locate the four screws. They are located on the back of the watch, at the four corners.

With the watch laying face-down, locate the four screws. They are located on the back of the watch, at the four corners.

Step 5

              Remove the 4 screws               

• Using a Torx-T5 screwdriver, remove each of the four 4mm screws and set them aside.

Using a Torx-T5 screwdriver, remove each of the four 4mm screws and set them aside.

Step 6

              Pry off the back of the watch.               

• Gently work the plastic opening tool under the top edge of the watch’s back cover.

Gently work the plastic opening tool under the top edge of the watch’s back cover.

Step 7

              Lift off the back cover               

• With the watch’s back cover pried loose, gently lift it away from the front half of the watch.

With the watch’s back cover pried loose, gently lift it away from the front half of the watch.

Step 8

              Set both halves of the watch aside               

• Lay both halves of the watch body assembly face down (with internal components facing up).

Lay both halves of the watch body assembly face down (with internal components facing up).

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    Keith Cooper                     

Member since: 09/25/2014

1,241 Reputation

                                      6 Guides authored                  



                       Badges:
                       13







                                                        +10 more badges                           

Team

                       USF Tampa, Team 1-7, Brown Fall 2014                        

                                                  Member of USF Tampa, Team 1-7, Brown Fall 2014 



                    USFT-BROWN-F14S1G7                     


                                            3 Members                     


                                            6 Guides authored                     

Dan Brown - Nov 13, 2014

Reply

Mention the screwdriver in the tools needed section.