Difficulty
Moderate
Steps
14
Time Required
Suggest a time??
Sections
2
- Casing
- 5 steps
- Heatsink
- 9 steps
Flags
1
Better Introduction
Improve this guide by completing or revising its introduction.
BackSamsung SmartCam HD Pro
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Casing
- Locate a small opening around the front panel of the camera.
Locate a small opening around the front panel of the camera.
1024
Step 2
- Using a plastic opening tool, apply pressure to various points around the camera to pry open the front panel.
Using a plastic opening tool, apply pressure to various points around the camera to pry open the front panel.
Step 3
- Remove both of the connecting wires from the motherboard.
- Be careful to not bend headers or damage the wires.
Remove both of the connecting wires from the motherboard.
Be careful to not bend headers or damage the wires.
Step 4
- Apply a plastic opening tool to the gray plastic band around the case of the camera. Insert the edge of the spudger between the case of the camera and the gray plastic band.
Apply a plastic opening tool to the gray plastic band around the case of the camera. Insert the edge of the spudger between the case of the camera and the gray plastic band.
Step 5
- Apply pressure with the plastic opening tool to various areas of the gray plastic band to pry it from the white plastic back of the case.
Apply pressure with the plastic opening tool to various areas of the gray plastic band to pry it from the white plastic back of the case.
Step 6
Heatsink
- On inside of front casing, locate heatsink.
On inside of front casing, locate heatsink.
Step 7
- Using careful force, push in the white tab and pry up heatsink with fingers.
Using careful force, push in the white tab and pry up heatsink with fingers.
Step 8
- Check to make sure all wires are completely detached from the motherboard.
Check to make sure all wires are completely detached from the motherboard.
Step 9
- Pull the circular circuit board away from the rest of the device, being careful not to bend any of the pins connecting the two.
Pull the circular circuit board away from the rest of the device, being careful not to bend any of the pins connecting the two.
Step 10
- Locate the three white tabs holding the next circuit board inside the case.
Locate the three white tabs holding the next circuit board inside the case.
Step 11
- Press each tab while using a plastic spudger to pry the motherboard up in the location near the tab.
Press each tab while using a plastic spudger to pry the motherboard up in the location near the tab.
Step 12
- Unplug the final group of wires from the bottom of the second circuit board and remove the board.
Unplug the final group of wires from the bottom of the second circuit board and remove the board.
Step 13
- On reverse side of second circuit board, locate secondary heatsink.
On reverse side of second circuit board, locate secondary heatsink.
Step 14
- Using a Phillips #00 screwdriver, remove the screws holding the heatsink to the motherboard.
Using a Phillips #00 screwdriver, remove the screws holding the heatsink to the motherboard.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
AllisonBridges
Member since: 01/18/2017
501 Reputation
5 Guides authored
Badges:
7
+4 more badges
Team
Arkansas State University, Team 1-1, Chamberlain Spring 2017
Member of Arkansas State University, Team 1-1, Chamberlain Spring 2017
ARSU-CHAMBERLAIN-S17S1G1
4 Members
12 Guides authored
