Difficulty

Moderate

Steps

10

Time Required

                          20 - 25 minutes

Sections

2

  • Casing
  • 5 steps
  • Motherboard
  • 5 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackSamsung SmartCam HD Pro

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Casing
  • Locate a small opening around the front panel of the camera.

Locate a small opening around the front panel of the camera.

1024

Step 2

  • Using a plastic opening tool, apply pressure to various points around the camera to pry open the front panel.

Using a plastic opening tool, apply pressure to various points around the camera to pry open the front panel.

Step 3

  • Remove both of the connecting wires from the motherboard.
  • Be careful to not bend headers or damage the wires.

Remove both of the connecting wires from the motherboard.

Be careful to not bend headers or damage the wires.

Step 4

  • Apply a plastic opening tool to the gray plastic band around the case of the camera. Insert the edge of the spudger between the case of the camera and the gray plastic band.

Apply a plastic opening tool to the gray plastic band around the case of the camera. Insert the edge of the spudger between the case of the camera and the gray plastic band.

Step 5

  • Apply pressure with the plastic opening tool to various areas of the gray plastic band to pry it from the white plastic back of the case.

Apply pressure with the plastic opening tool to various areas of the gray plastic band to pry it from the white plastic back of the case.

Step 6

              Motherboard
  • Check to make sure all wires are completely detached from the motherboard.

Check to make sure all wires are completely detached from the motherboard.

Step 7

  • Pull the circular circuit board away from the rest of the device, being careful not to bend any of the pins connecting the two.

Pull the circular circuit board away from the rest of the device, being careful not to bend any of the pins connecting the two.

Step 8

  • Locate the three white tabs holding the next circuit board inside the case.

Locate the three white tabs holding the next circuit board inside the case.

Step 9

  • Press each tab while using a plastic opening tool to pry the motherboard up in the location near the tab.

Press each tab while using a plastic opening tool to pry the motherboard up in the location near the tab.

Step 10

  • Unplug the final group of wires from the bottom of the second circuit board.

Unplug the final group of wires from the bottom of the second circuit board.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    AllisonBridges

Member since: 01/18/2017

501 Reputation

                                      5 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       Arkansas State University, Team 1-1, Chamberlain Spring 2017                        

                                                  Member of Arkansas State University, Team 1-1, Chamberlain Spring 2017 



                    ARSU-CHAMBERLAIN-S17S1G1                     


                                            4 Members                     


                                            12 Guides authored