Difficulty

Difficult

Steps

12

Time Required

                          25 minutes

Sections

4

  • Disassembling Samsung HMX-W300
  • 5 steps
  • Battery
  • 3 steps
  • USB Port
  • 3 steps
  • Front Case
  • 1 step

Flags

0

  • BackSamsung HMX-W300

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Disassembling Samsung HMX-W300
  • To remove the wristband of the device, grab the middle loop and pull the band through.

To remove the wristband of the device, grab the middle loop and pull the band through.

1024

Step 2

  • Remove four screws with a Hex 1.5 mm screwdriver.

Remove four screws with a Hex 1.5 mm screwdriver.

Step 3

  • Open the HDMI door on the side of the camera.
  • Remove the single screw using a Phillips #00 screwdriver.

Open the HDMI door on the side of the camera.

Remove the single screw using a Phillips #00 screwdriver.

Step 4

  • Use the iFixit opening tool on both sides on the device. Pry apart both sections with light force.
  • Do not apply too much force. There is a wire that attaches the front case with the rear case that can be damaged.

Use the iFixit opening tool on both sides on the device. Pry apart both sections with light force.

Do not apply too much force. There is a wire that attaches the front case with the rear case that can be damaged.

Step 5

  • Pull the wire ribbon out with a pair of tweezers.

Pull the wire ribbon out with a pair of tweezers.

Step 6

              Battery
  • Remove the four screws from the battery housing using a Phillips #00 screwdriver.

Remove the four screws from the battery housing using a Phillips #00 screwdriver.

Step 7

  • Use the iFixit opening tool to pry the battery housing open.

Use the iFixit opening tool to pry the battery housing open.

Step 8

  • After removing the battery housing, take the battery out.

After removing the battery housing, take the battery out.

Step 9

              USB Port
  • Use an iFixit opening tool to pry up the plastic cover.
  • Use tweezers to remove the wire from the slots.

Use an iFixit opening tool to pry up the plastic cover.

Use tweezers to remove the wire from the slots.

Step 10

  • Remove both screws from the USB port using a Phillips #00 screwdriver.

Remove both screws from the USB port using a Phillips #00 screwdriver.

Step 11

  • Push the USB port inside the case to remove it from the device.

Push the USB port inside the case to remove it from the device.

Step 12

              Front Case
  • The front case is separated from the rest of the device.

The front case is separated from the rest of the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 6 other contributors 


                    Robert

Member since: 01/21/2015

966 Reputation

                                      8 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       USF Tampa, Team 9-2, Blackwell Winter 2015                        

                                                  Member of USF Tampa, Team 9-2, Blackwell Winter 2015 



                    USFT-BLACKWELL-W15S9G2                     


                                            4 Members                     


                                            16 Guides authored