Difficulty

Difficult

Steps

13

Time Required

                          35 minutes

Sections

3

  • Disassembling Samsung HMX-W300
  • 5 steps
  • Motherboard
  • 5 steps
  • LCD Screen
  • 3 steps

Flags

0

  • BackSamsung HMX-W300

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Disassembling Samsung HMX-W300
  • To remove the wristband of the device, grab the middle loop and pull the band through.

To remove the wristband of the device, grab the middle loop and pull the band through.

1024

Step 2

  • Remove four screws with a Hex 1.5 mm screwdriver.

Remove four screws with a Hex 1.5 mm screwdriver.

Step 3

  • Open the HDMI door on the side of the camera.
  • Remove the single screw using a Phillips #00 screwdriver.

Open the HDMI door on the side of the camera.

Remove the single screw using a Phillips #00 screwdriver.

Step 4

  • Use the iFixit opening tool on both sides on the device. Pry apart both sections with light force.
  • Do not apply too much force. There is a wire that attaches the front case with the rear case that can be damaged.

Use the iFixit opening tool on both sides on the device. Pry apart both sections with light force.

Do not apply too much force. There is a wire that attaches the front case with the rear case that can be damaged.

Step 5

  • Pull the wire ribbon out with a pair of tweezers.

Pull the wire ribbon out with a pair of tweezers.

Step 6

              Remove tape.
  • Use tweezers to remove the tape.

Use tweezers to remove the tape.

Step 7

              Unplug wire ribbon.
  • Use tweezers to grab the wire ribbon, then pull the wire out of connection.

Use tweezers to grab the wire ribbon, then pull the wire out of connection.

Step 8

              Remove scerws.
  • There are 5 Phillips size 00 screws. Remove all 5 screws.
  • Wire ribbon is attached to the motherboard.

There are 5 Phillips size 00 screws. Remove all 5 screws.

Wire ribbon is attached to the motherboard.

Step 9

  • Pry the motherboard up using the plastic opening tool.
  • Be careful there is a wire ribbon holding the motherboard.

Pry the motherboard up using the plastic opening tool.

Be careful there is a wire ribbon holding the motherboard.

Step 10

              Disconnect wire ribbon.
  • Use tweezers to disconnect the wire as shown. This will loosen the motherboard from the rear case.

Use tweezers to disconnect the wire as shown. This will loosen the motherboard from the rear case.

Step 11

              Remove screws.
  • Use Phillips size 00 and remove the 3 screws as shown.

Use Phillips size 00 and remove the 3 screws as shown.

Step 12

              Pry screen.
  • Pry the end of the screen with the plastic opening tool.

Pry the end of the screen with the plastic opening tool.

Step 13

  • Grab the end of the screen, then pull towards the inside of the case. This is a bit tricky. This will release tabs at the top of the screen to the rear case.

Grab the end of the screen, then pull towards the inside of the case. This is a bit tricky. This will release tabs at the top of the screen to the rear case.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 5 other contributors 


                    Robert

Member since: 01/21/2015

966 Reputation

                                      8 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       USF Tampa, Team 9-2, Blackwell Winter 2015                        

                                                  Member of USF Tampa, Team 9-2, Blackwell Winter 2015 



                    USFT-BLACKWELL-W15S9G2                     


                                            4 Members                     


                                            16 Guides authored