Difficulty

Moderate

Steps

7

Time Required

                          6 minutes

Sections

3

  • Battery
  • 2 steps
  • Rear Case
  • 3 steps
  • Antenna
  • 2 steps

Flags

0

  • BackSamsung Jack

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Slide the battery cover downwards with pressure focused on the center of the cover.
  • Lift the cover off of the phone.

Slide the battery cover downwards with pressure focused on the center of the cover.

Lift the cover off of the phone.

1024

Step 2

  • Grasp the bottom left and right corners of the battery and lift it from its housing.

Grasp the bottom left and right corners of the battery and lift it from its housing.

Step 3

              Rear Case
  • Remove the four black 7.30 mm screws surrounding the battery housing using a Phillips #00 Screwdriver.

Remove the four black 7.30 mm screws surrounding the battery housing using a Phillips #00 Screwdriver.

Step 4

  • The rear case is firmly attached to the phone with clips. Do not be afraid to use a little extra force.
  • Insert the Plastic Opening Tool in between the front and rear cases.
  • Pry with the Plastic Opening Tool around all edges of the phone until you free all the clips.

The rear case is firmly attached to the phone with clips. Do not be afraid to use a little extra force.

Insert the Plastic Opening Tool in between the front and rear cases.

Pry with the Plastic Opening Tool around all edges of the phone until you free all the clips.

Step 5

  • Lift the rear case off of the phone.

Lift the rear case off of the phone.

Step 6

              Antenna
  • Remove the two silver 4.30 mm screws on either side of the antenna using a Phillip’s #00 Screwdriver.

Remove the two silver 4.30 mm screws on either side of the antenna using a Phillip’s #00 Screwdriver.

Step 7

  • There is a wire under the antenna connecting it to the Motherboard. Do not pull off the antenna just yet.
  • Use a spudger to remove the wire connector under the antenna.

There is a wire under the antenna connecting it to the Motherboard. Do not pull off the antenna just yet.

Use a spudger to remove the wire connector under the antenna.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 6 other contributors 


                    Paul Piller

Member since: 04/12/2011

56 Reputation

                                      5 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Cal Poly, Team 24-57, Amido Spring 2011                        

                                                  Member of Cal Poly, Team 24-57, Amido Spring 2011 



                    CPSU-AMIDO-S11S24G57                     


                                            4 Members                     


                                            7 Guides authored