Difficulty

Moderate

Steps

6

Time Required

                          10 minutes

Sections

3

  • Stand
  • 2 steps
  • Rear Case
  • 1 step
  • T-Con Board
  • 3 steps

Flags

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackSamsung LN-T5265F

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Stand
  • Lay the TV screen-side down on a flat, soft surface.
  • Remove four Phillips screws attaching the stand to the TV.

Lay the TV screen-side down on a flat, soft surface.

Remove four Phillips screws attaching the stand to the TV.

1024

Step 2

  • Slide the stand out from the bottom of the TV.

Slide the stand out from the bottom of the TV.

Step 3

              Rear Case
  • Remove fifteen Phillips screws securing the rear case to the front.
  • If present, remove four Phillips screws for the VESA mount.
  • Carefully lift the rear case upwards to separate it from the frame of the TV.

Remove fifteen Phillips screws securing the rear case to the front.

If present, remove four Phillips screws for the VESA mount.

Carefully lift the rear case upwards to separate it from the frame of the TV.

Step 4

              T-Con Board
  • The Timing Controller (T-Con) board is located at the top center behind a metal shield.
  • Remove four Phillips screws.
  • Tilt the metal shield towards the top of the TV and lift away.

The Timing Controller (T-Con) board is located at the top center behind a metal shield.

Remove four Phillips screws.

Tilt the metal shield towards the top of the TV and lift away.

Step 5

  • Disconnect the two ribbon cables at the top by flipping up the retaining flaps and sliding the ribbons straight up towards the top of the TV.

Disconnect the two ribbon cables at the top by flipping up the retaining flaps and sliding the ribbons straight up towards the top of the TV.

Step 6

  • Disconnect the bottom ribbon cable by depressing the two buttons on either side of the connector and sliding down towards the bottom of the TV.

Disconnect the bottom ribbon cable by depressing the two buttons on either side of the connector and sliding down towards the bottom of the TV.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 1 other contributor 


                    Steven Carlton

Member since: 08/19/2013

606 Reputation

                                      3 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges