Samsung Ml2510 Rear Cooling Fan Replacement Repair Guide

Difficulty

Easy

Steps

5

Time Required

                          5 - 10 minutes            

Sections

2

• Removing Samsung ML2510 Back Panel
• 3 steps
• Rear Cooling Fan
• 2 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

• BackSamsung ML-2510

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Removing Samsung ML2510 Back Panel               

• Remove the top hinged panel by taking out the pins at the bottom of this panel.

Remove the top hinged panel by taking out the pins at the bottom of this panel.

1024

Step 2

• Using a Phillips #2 screwdriver, remove the four screws on the back of the printer.

Using a Phillips #2 screwdriver, remove the four screws on the back of the printer.

Step 3

• Gently lift the top panel while simultaneously pulling off the back panel.
• Before pulling out the back panel entirely, make sure to remove the rear cooling fan from its slot.

Gently lift the top panel while simultaneously pulling off the back panel.

Before pulling out the back panel entirely, make sure to remove the rear cooling fan from its slot.

Step 4

              Rear Cooling Fan               

• Once the fan is detached, unplug the fan from the circuit board.
• Slide the fan’s wiring through the anchored slit.

Once the fan is detached, unplug the fan from the circuit board.

Slide the fan’s wiring through the anchored slit.

Step 5

• With the new fan, thread the wiring through the old fan’s slit.
• Reconnect the fan by plugging it back into the circuit board.
• Reattach the back panel following these instructions in reverse order.

With the new fan, thread the wiring through the old fan’s slit.

Reconnect the fan by plugging it back into the circuit board.

Reattach the back panel following these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 6 other contributors 

                    bbaustin                     

Member since: 10/12/2011

247 Reputation

                                      6 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges                           

Team

                       Cal Poly, Team 17-18, Regan Fall 2011                        

                                                  Member of Cal Poly, Team 17-18, Regan Fall 2011 



                    CPSU-REGAN-F11S17G18                     


                                            4 Members                     


                                            6 Guides authored                     

Bax Bagatelli - Oct 19, 2015

Reply

My printer is in this state currently. What is the type of fan (brand/specs) that needs to be installed? And perhaps also, where does one obtain such a fan?