Difficulty
Moderate
Steps
8
Time Required
10 - 15 minutes
Sections
3
- Battery
- 3 steps
- Back Panel
- 3 steps
- RAM
- 2 steps
Flags
0
BackSamsung NP-N150-JPB1US
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Turn off the computer.
- Disconnect the charging cable from the laptop.
- Failure to unplug the cable could result in electric shock.
- Flip the laptop upside down with the front face down on a flat surface.
Turn off the computer.
Disconnect the charging cable from the laptop.
Failure to unplug the cable could result in electric shock.
Flip the laptop upside down with the front face down on a flat surface.
1024
Step 2
- Slide the left and right switch to the “unlocked” position.
Slide the left and right switch to the “unlocked” position.
Step 3
- While holding the left and right hand switches in the “unlocked” position, push the battery away from the computer.
While holding the left and right hand switches in the “unlocked” position, push the battery away from the computer.
Step 4
Back Panel
- Using the Phillip’s 00 screwdriver, unscrew the fourteen 7mm screws until the back panel comes loose.
Using the Phillip’s 00 screwdriver, unscrew the fourteen 7mm screws until the back panel comes loose.
Step 5
- Using either the blue plastic opening tools or spudger tool, wedge one in between the back panel and the laptop.
- Apply pressure upwards till the back panel pops off.
- If the back panel is difficult to remove and feels like it is going to break, DO NOT force it. Check to confirm that all the screws are removed before attempting again.
Using either the blue plastic opening tools or spudger tool, wedge one in between the back panel and the laptop.
Apply pressure upwards till the back panel pops off.
If the back panel is difficult to remove and feels like it is going to break, DO NOT force it. Check to confirm that all the screws are removed before attempting again.
Step 6
- The computer should be open with the motherboard exposed and internal components exposed. You should now be able to access the Fan and RAM. There are more necessary steps to follow before accessing the screen and keyboard.
The computer should be open with the motherboard exposed and internal components exposed. You should now be able to access the Fan and RAM. There are more necessary steps to follow before accessing the screen and keyboard.
Step 7
RAM
- Using your hands, push the two metal clip holders on each side away from the RAM till you hear a clicking sound.
- If you push the metal rods away from the RAM as directed, the RAM will pop up at an angle.
Using your hands, push the two metal clip holders on each side away from the RAM till you hear a clicking sound.
If you push the metal rods away from the RAM as directed, the RAM will pop up at an angle.
Step 8
- Gently pull out the stick of RAM.
Gently pull out the stick of RAM.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
patrick Russell
Member since: 04/03/2016
788 Reputation
6 Guides authored
Badges:
14
+11 more badges
Team
Eastern Washington University, Team 2-3, Andersen Spring 2016
Member of Eastern Washington University, Team 2-3, Andersen Spring 2016
EWU-ANDERSEN-S16S2G3
5 Members
6 Guides authored
Fred - Jul 4, 2018
Reply
There is no need to open the entire casing. There is a special lid on the back that covers the SODIMM for easy access. It can be replaced removing only one screw.
