Difficulty

Moderate

Steps

9

Time Required

                          20 minutes

Sections

2

  • Battery
  • 5 steps
  • Wi-Fi Card
  • 4 steps

Flags

0

  • BackSamsung Notebook 7 Spin NP740U3MK01US

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Flip your laptop over so that the back is face up.

Flip your laptop over so that the back is face up.

1024

Step 2

  • Use a Phillips #00 screwdriver to remove the four 6.5mm screws and the six 4.5mm screws that secure the back plate.

Use a Phillips #00 screwdriver to remove the four 6.5mm screws and the six 4.5mm screws that secure the back plate.

Step 3

  • Use a plastic opening tool to remove the back plate from the laptop.
  • It is recommended that you start from a corner then run the tool along the edge of the back plate.

Use a plastic opening tool to remove the back plate from the laptop.

It is recommended that you start from a corner then run the tool along the edge of the back plate.

Step 4

  • Use a Phillips #00 screwdriver to remove the three 4.5 mm screws holding the battery in place.

Use a Phillips #00 screwdriver to remove the three 4.5 mm screws holding the battery in place.

Step 5

  • Use a spudger to pry the battery connecting cable from the laptop and remove the battery.
  • Using the metal spudger may severely damage the internal components in your device.

Use a spudger to pry the battery connecting cable from the laptop and remove the battery.

Using the metal spudger may severely damage the internal components in your device.

Step 6

              Wi-Fi Card
  • Use the Phillips #00 screwdriver to remove the two 4.5mm screws holding the cover plate in place.

Use the Phillips #00 screwdriver to remove the two 4.5mm screws holding the cover plate in place.

Step 7

  • Remove the black ribbon cable by pulling up on the black cover and sliding out the cable.

Remove the black ribbon cable by pulling up on the black cover and sliding out the cable.

Step 8

  • Remove the three black and white cables by gently pulling on them.

Remove the three black and white cables by gently pulling on them.

Step 9

  • Use the Phillips #00 screwdriver to remove the two 4.5mm screws holding the USB board down and remove the board.

Use the Phillips #00 screwdriver to remove the two 4.5mm screws holding the USB board down and remove the board.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Alexander Ulman

Member since: 09/16/2019

361 Reputation

                                      2 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       Embry-Riddle Aeronautical University, Team S23-G3, McClure Fall 2019                        

                                                  Member of Embry-Riddle Aeronautical University, Team S23-G3, McClure Fall 2019 



                    ERAU-MCCLURE-F19S23G3                     


                                            4 Members                     


                                            5 Guides authored