Difficulty

Moderate

Steps

5

Time Required

                          10 - 20 minutes

Sections

1

  • Speaker
  • 5 steps

Flags

0

  • BackSamsung NP-N102S-B05PH

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Speaker
  • Place the laptop face-down on a stable surface.
  • Remove the nine 6.5mm Phillips #0 screws shown.
  • Use the blue opening tool to gently pry the back of the laptop off of the body.

Place the laptop face-down on a stable surface.

Remove the nine 6.5mm Phillips #0 screws shown.

Use the blue opening tool to gently pry the back of the laptop off of the body.

1024

Step 2

  • Use a Phillips #0 screwdriver to remove the six 4.5mm screws holding the motherboard to the case.

Use a Phillips #0 screwdriver to remove the six 4.5mm screws holding the motherboard to the case.

Step 3

  • Use the spudger to remove the red and black cable located above the speaker from it’s connector.
  • Also using the spudger, remove the small ribbon cable located a the bottom of the motherboard, towards the middle.
  • Fold the motherboard back, using the computer hinge as the axis of rotation. The motherboard will still be attached to the case by a few wires.

Use the spudger to remove the red and black cable located above the speaker from it’s connector.

Also using the spudger, remove the small ribbon cable located a the bottom of the motherboard, towards the middle.

Fold the motherboard back, using the computer hinge as the axis of rotation. The motherboard will still be attached to the case by a few wires.

Step 4

  • Gently unhook the red and black wires from the plastic clips holding them to the case. This can be done with only your fingers.

Gently unhook the red and black wires from the plastic clips holding them to the case. This can be done with only your fingers.

Step 5

  • Using the spudger, lift the speaker up and out of it’s holder, as shown. The yellow plastic tape should peel off as well.

Using the spudger, lift the speaker up and out of it’s holder, as shown. The yellow plastic tape should peel off as well.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Lennon Grimm

Member since: 10/04/2016

220 Reputation

                                      2 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       USF Tampa, Team 2-4, Nance Fall 2016                        

                                                  Member of USF Tampa, Team 2-4, Nance Fall 2016 



                    USFT-NANCE-F16S2G4                     


                                            4 Members                     


                                            5 Guides authored