Difficulty

Moderate

Steps

10

Time Required

                          10 - 15 minutes

Sections

2

  • Hard Drive
  • 3 steps
  • Display
  • 7 steps

Flags

0

  • BackSamsung NP510R5E-A01UB

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Hard Drive
  • Make sure the device is powered off before beginning.
  • Using the Phillips #0 screwdriver, remove the 6.5mm long screw in the area circled.

Make sure the device is powered off before beginning.

Using the Phillips #0 screwdriver, remove the 6.5mm long screw in the area circled.

1024

Step 2

  • With the cover removed, unscrew all four of the 4.75mm long screws using the Phillips #0 screwdriver.

With the cover removed, unscrew all four of the 4.75mm long screws using the Phillips #0 screwdriver.

Step 3

  • Unplug the connector from the hard drive by pulling straight out.

Unplug the connector from the hard drive by pulling straight out.

Step 4

              Display
  • Remove the two rubber feet with arrows by them on the back side to uncover two screws.
  • Unscrew the four silver 4.4mm long screws near the hard drive.
  • Unscrew the remaining nine black 6.5mm long screws. Then remove the back casing using a pry tool if needed.

Remove the two rubber feet with arrows by them on the back side to uncover two screws.

Unscrew the four silver 4.4mm long screws near the hard drive.

Unscrew the remaining nine black 6.5mm long screws. Then remove the back casing using a pry tool if needed.

Step 5

  • Disconnect the black and white cables by pulling up as pictured.

Disconnect the black and white cables by pulling up as pictured.

Step 6

  • Disconnect the black cable by pulling straight out.

Disconnect the black cable by pulling straight out.

Step 7

  • Unscrew the two 4.45mm long screws to disconnect the left hinge.
  • Unscrew the two 4.45mm long screws to disconnect the right hinge.
  • At this point the screen and plastic housing should be completely disconnected.

Unscrew the two 4.45mm long screws to disconnect the left hinge.

Unscrew the two 4.45mm long screws to disconnect the right hinge.

At this point the screen and plastic housing should be completely disconnected.

Step 8

  • Using the plastic opening tool, pry open the plastic housing that holds the display.

Using the plastic opening tool, pry open the plastic housing that holds the display.

Step 9

  • Unscrew the four 3.55mm long screws that hold the display in place.

Unscrew the four 3.55mm long screws that hold the display in place.

Step 10

  • Disconnect the last cable by pulling straight out.

Disconnect the last cable by pulling straight out.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Dominic Simpson

Member since: 02/14/2018

245 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       USF Tampa, Team S6-G5, Eyestone Spring 2018                        

                                                  Member of USF Tampa, Team S6-G5, Eyestone Spring 2018 



                    USFT-EYESTONE-S18S6G5                     


                                            3 Members                     


                                            8 Guides authored