Difficulty
Moderate
Steps
9
Time Required
Suggest a time??
Sections
2
- Viewfinder Focus Dial
- 2 steps
- Back Cover
- 7 steps
Flags
0
BackSamsung NX1
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Viewfinder Focus Dial
- Push the rubber viewfinder grip upward.
Push the rubber viewfinder grip upward.
1024
Step 2
- Use the Phillips #00 screwdriver to remove one 6.4 mm screw in the center of the dial.
- Remove the dial by lifting upward with your fingers.
Use the Phillips #00 screwdriver to remove one 6.4 mm screw in the center of the dial.
Remove the dial by lifting upward with your fingers.
Step 3
Back Cover
- Use the Phillips #00 screwdriver to remove the four 5.5 mm screws surrounding the viewfinder.
- Use your fingers to lift the plastic viewfinder cover upward.
Use the Phillips #00 screwdriver to remove the four 5.5 mm screws surrounding the viewfinder.
Use your fingers to lift the plastic viewfinder cover upward.
Step 4
- Use the Phillips #00 screwdriver to remove the two 5.5 mm screws from the right side of the camera above the SD card port.
Use the Phillips #00 screwdriver to remove the two 5.5 mm screws from the right side of the camera above the SD card port.
Step 5
- Use the Phillips #00 screwdriver to remove one 5.5 mm screw on the left, above the HDMI port.
Use the Phillips #00 screwdriver to remove one 5.5 mm screw on the left, above the HDMI port.
Step 6
- Use the Phillips #00 screwdriver to remove the five 5.5 mm screws from the bottom, near the battery compartment.
- Use the Phillips #00 screwdriver to remove one 3.8 mm screw from the bottom of the hand grip, below the battery compartmen.
Use the Phillips #00 screwdriver to remove the five 5.5 mm screws from the bottom, near the battery compartment.
Use the Phillips #00 screwdriver to remove one 3.8 mm screw from the bottom of the hand grip, below the battery compartmen.
Step 7
- Use a plastic opening tool to separate the back cover from the front cover.
- Pry the back cover in this order: bottom, right side, left side.
Use a plastic opening tool to separate the back cover from the front cover.
Pry the back cover in this order: bottom, right side, left side.
Step 8
- Use your fingers to pull the back cover away from the front cover.
- Do not completely separate the back cover from the front cover as two cables hold these components together.
Use your fingers to pull the back cover away from the front cover.
Do not completely separate the back cover from the front cover as two cables hold these components together.
Step 9
- Use tweezers to pull the two ribbon cables horizontally out of their clips.
Use tweezers to pull the two ribbon cables horizontally out of their clips.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Hannah Patrick
Member since: 02/24/2016
891 Reputation
6 Guides authored
Badges:
13
+10 more badges
Team
USF Tampa, Team 1-4, Leahy Spring 2016
Member of USF Tampa, Team 1-4, Leahy Spring 2016
USFT-LEAHY-S16S1G4
3 Members
6 Guides authored
