Difficulty
Difficult
Steps
8
Time Required
40 minutes
Sections
1
- LCD
- 8 steps
Flags
0
BackSamsung NX2000
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
LCD
- First begin by flipping your camera upside down.
- Remove the seven 4mm screws from indicated circles shown using a Y0 screwdriver. There are three on the bottom, and two on each side
- Remember to store the screws in a secure place.
First begin by flipping your camera upside down.
Remove the seven 4mm screws from indicated circles shown using a Y0 screwdriver. There are three on the bottom, and two on each side
Remember to store the screws in a secure place.
1024
Step 2
- Insert a plastic opening tool into the gab between the camera body and the back panel. Carefully pry open the camera and separate the back panel.
- When working with electronics, it’s important to choose a tool that’s ESD-safe to avoid accidental damage to the device. The metal spudger is great when you need serious prying power, but the regular black nylon spudger or a plastic opening tool should be used whenever possible.
Insert a plastic opening tool into the gab between the camera body and the back panel. Carefully pry open the camera and separate the back panel.
When working with electronics, it’s important to choose a tool that’s ESD-safe to avoid accidental damage to the device. The metal spudger is great when you need serious prying power, but the regular black nylon spudger or a plastic opening tool should be used whenever possible.
Step 3
- Before taking it apart you’ll have to detach the display ribbon cable.
- Use a plastic opening tool, lift up the black strip to release the ribbon cable from the connector.
Before taking it apart you’ll have to detach the display ribbon cable.
Use a plastic opening tool, lift up the black strip to release the ribbon cable from the connector.
Step 4
- Separate the LCD half compartment of the camera from the main body.
Separate the LCD half compartment of the camera from the main body.
Step 5
- Remove the four 1mm screws with the Y0 screwdriver.
Remove the four 1mm screws with the Y0 screwdriver.
Step 6
- Use a plastic opening tool or tweezers to lift the green tape located on top of the LCD controller board.
- Detach the two ribbon cables, by first lifting the black tab on top of the connector.
- Pull the ribbon cables out of the connectors with tweezers or two fingers.
Use a plastic opening tool or tweezers to lift the green tape located on top of the LCD controller board.
Detach the two ribbon cables, by first lifting the black tab on top of the connector.
Pull the ribbon cables out of the connectors with tweezers or two fingers.
Step 7
- Place blue plastic spudger in between LCD screen and plastic surrounding.
- Begin to lift up slowly, removing the LCD screen from the main frame.
Place blue plastic spudger in between LCD screen and plastic surrounding.
Begin to lift up slowly, removing the LCD screen from the main frame.
Step 8
- The LCD screen is now separated form the main frame.
The LCD screen is now separated form the main frame.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 3 other contributors
Maria Zamora
Member since: 02/09/2016
155 Reputation
1 Guide authored
Badges:
6
+3 more badges
Team
USF Tampa, Team 7-4, Cheng Spring 2016
Member of USF Tampa, Team 7-4, Cheng Spring 2016
USFT-CHENG-S16S7G4
4 Members
10 Guides authored
