Difficulty

Moderate

Steps

7

Time Required

                          15 minutes

Sections

2

  • Battery
  • 3 steps
  • Screen
  • 4 steps

Flags

1

Missed a Step

Oops! This guide is currently missing some important steps.

  • BackSamsung NX30

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Flip the camera over so that the bottom of the camera is up.
  • Push the battery switch towards the back of the camera.

Flip the camera over so that the bottom of the camera is up.

Push the battery switch towards the back of the camera.

1024

Step 2

  • Locate the blue switch above the battery pack.
  • Slide the blue switch into the camera in the direction of the arrow on the switch. When the switch has been pushed in the battery will spring up.

Locate the blue switch above the battery pack.

Slide the blue switch into the camera in the direction of the arrow on the switch. When the switch has been pushed in the battery will spring up.

Step 3

  • Pull the battery out.

Pull the battery out.

Step 4

              Screen
  • Unscrew the nine 4mm Phillips head screws surrounding the body of the camera. They are located on the bottom of the camera and both sides of the camera.

Unscrew the nine 4mm Phillips head screws surrounding the body of the camera. They are located on the bottom of the camera and both sides of the camera.

Step 5

  • Pull the viewer out from the camera and then up.
  • Unscrew the two black 4mm Phillips head screws under it.

Pull the viewer out from the camera and then up.

Unscrew the two black 4mm Phillips head screws under it.

Step 6

  • Once the screws are all removed, place the camera face down, with the screen facing up.
  • Pry open the body using the plastic opening tool.
  • Gently open the body.

Once the screws are all removed, place the camera face down, with the screen facing up.

Pry open the body using the plastic opening tool.

Gently open the body.

Step 7

  • Then use the plastic opening tool to dislodge the Ribbon Cable, located near the top of the camera, from the Circuit Board.
  • The Ribbon Cable will be disconnected from the Circuit Board when you are done.

Then use the plastic opening tool to dislodge the Ribbon Cable, located near the top of the camera, from the Circuit Board.

The Ribbon Cable will be disconnected from the Circuit Board when you are done.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors 


                    Julia Kilcup

Member since: 02/03/2016

384 Reputation

                                      3 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges

Team

                       UW Tacoma, Team 1-4, Rose Winter 2016                        

                                                  Member of UW Tacoma, Team 1-4, Rose Winter 2016 



                    UWT-ROSE-W16S1G4                     


                                            4 Members                     


                                            10 Guides authored