Difficulty
Moderate
Steps
11
Time Required
Suggest a time??
Sections
3
- Battery
- 1 step
- Lens Assembly
- 3 steps
- Back Case
- 7 steps
Flags
0
BackSamsung NX3000
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
We highly suggest you use a magnetic project mat or an organization tray. This camera has many different types of screws and keeping them organized is key to proper reassembly.
What you need
Step 1
Battery
- If you haven’t done so already, remove the lens from the camera.
- Turn the camera upside down.
- Slide the button to the left to open the battery compartment.
- Push the blue button up to release the battery.
- The battery is not shown in these photos.
If you haven’t done so already, remove the lens from the camera.
Turn the camera upside down.
Slide the button to the left to open the battery compartment.
Push the blue button up to release the battery.
The battery is not shown in these photos.
1024
Step 2
Lens Assembly
- Remove the four 7.3 mm Phillips screws from the front of the lens assembly.
- Remove the silver ring with tweezers.
Remove the four 7.3 mm Phillips screws from the front of the lens assembly.
Remove the silver ring with tweezers.
Step 3
- Use tweezers to remove the black plastic ring and small metal ring inside the lens assembly.
Use tweezers to remove the black plastic ring and small metal ring inside the lens assembly.
Step 4
- Use tweezers to lift the pyramid screw and spring from the lens assembly.
Use tweezers to lift the pyramid screw and spring from the lens assembly.
Step 5
Back Case
- Remove the three 4.3 mm Phillips screws from the bottom of the camera.
- Remove the 4.3 mm Phillips screw hiding inside the battery compartment.
Remove the three 4.3 mm Phillips screws from the bottom of the camera.
Remove the 4.3 mm Phillips screw hiding inside the battery compartment.
Step 6
- Remove the 4.2 mm Phillips screw from the left handgrip.
- Remove the two 4.2 mm Phillips screws from the right handgrip.
Remove the 4.2 mm Phillips screw from the left handgrip.
Remove the two 4.2 mm Phillips screws from the right handgrip.
Step 7
- Use tweezers to remove the metal shield from the external flash mount.
Use tweezers to remove the metal shield from the external flash mount.
Step 8
- Remove the four 5 mm Phillips screws from the external flash mount .
Remove the four 5 mm Phillips screws from the external flash mount .
Step 9
- Remove the external flash mount.
Remove the external flash mount.
Step 10
- Slowly pull the bottom of the back case away from the camera.
- Do not attempt to remove the back case as it is attached to the motherboard by a ribbon cable.
Slowly pull the bottom of the back case away from the camera.
Do not attempt to remove the back case as it is attached to the motherboard by a ribbon cable.
Step 11
- Use the flat end of a spudger to pry the flat topped connector straight up from the motherboard.
- Remove the back case.
Use the flat end of a spudger to pry the flat topped connector straight up from the motherboard.
Remove the back case.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
Kelsea Weber
Member since: 11/12/2015
18,948 Reputation
32 Guides authored
Badges:
47
+44 more badges
Team
iFixit
Member of iFixit
Community
141 Members
15,767 Guides authored
