Difficulty
Easy
Steps
5
Time Required
3 minutes
Sections
1
- Battery
- 5 steps
Flags
0
BackSamsung POWERbot VR9000
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Turn off the emergency switch located at the bottom right of the POWERbot.
Turn off the emergency switch located at the bottom right of the POWERbot.
1024
Step 2
- Unscrew the two 6mm Phillips #1 screws and remove the lid, exposing the battery.
Unscrew the two 6mm Phillips #1 screws and remove the lid, exposing the battery.
Step 3
- Follow the wires and find the small white box next to the battery.
- On the side of the white box facing the battery, find the rigid tab.
Follow the wires and find the small white box next to the battery.
On the side of the white box facing the battery, find the rigid tab.
Step 4
- Push the tab inwards to the white box and pull the wires up. This will release the wires from the white box, allowing you to remove the battery.
Push the tab inwards to the white box and pull the wires up. This will release the wires from the white box, allowing you to remove the battery.
Step 5
- Remove the battery by holding the battery in place and partially righting the POWERbot so the battery falls out.
Remove the battery by holding the battery in place and partially righting the POWERbot so the battery falls out.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
4 other people completed this guide.
Author
with 3 other contributors
Alexandra Jensen
Member since: 04/24/2017
138 Reputation
1 Guide authored
Badges:
5
+2 more badges
Team
Cal Poly, Team S15-G3, Banghart Spring 2017
Member of Cal Poly, Team S15-G3, Banghart Spring 2017
CPSU-BANGHART-S17S15G3
4 Members
14 Guides authored