Samsung Powerbot Vr9000 Powerbrush Replacement Repair Guide

Difficulty

Very easy

Steps

4

Time Required

                          1 minute            

Sections

1

• Powerbrush
• 4 steps

Flags

0

• BackSamsung POWERbot VR9000

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

Step 1

              Powerbrush               

• Turn off the emergency switch located at the bottom right of the POWERbot.

Turn off the emergency switch located at the bottom right of the POWERbot.

1024

Step 2

• Press the two yellow tabs immediately below the POWERbrush.

Press the two yellow tabs immediately below the POWERbrush.

Step 3

• Lift the brush cover, indicated by the yellow strip located above the yellow tabs.

Lift the brush cover, indicated by the yellow strip located above the yellow tabs.

Step 4

• Remove the power brush starting with the unhinged right side of the brush.

Remove the power brush starting with the unhinged right side of the brush.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    Harrison Fugate                     

Member since: 04/24/2017

102 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       Cal Poly, Team S15-G3, Banghart Spring 2017                        

                                                  Member of Cal Poly, Team S15-G3, Banghart Spring 2017 



                    CPSU-BANGHART-S17S15G3                     


                                            4 Members                     


                                            14 Guides authored                     

Charlie nguyen - Jan 15, 2020

Reply

The brush is wobbly in position. Is there an insert on the right side of the brush at the bearing. This position, the bearing look too small for the opening of the cover and the upper plastic.

hawkswhispertwh - Feb 10, 2020

Reply

Did you lose the rubber cover/ washer that goes over the bearing? You can replace it from Samsung if you did.