Samsung Radiant 360 R1 Micro Usb Power Port Panel Replacement Repair Guide

Difficulty

Easy

Steps

5

Time Required

                          10 minutes            

Sections

1

• Micro USB / Power Port Panel
• 5 steps

Flags

0

• BackSamsung Radiant 360 R1

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Micro USB / Power Port Panel               

• Working on your device while it is turned on may result in electric shock. Make sure to shut down and unplug your device before you begin.
• Use the plastic opening tool to lift and remove the rubber grommet plugs.

Working on your device while it is turned on may result in electric shock. Make sure to shut down and unplug your device before you begin.

Use the plastic opening tool to lift and remove the rubber grommet plugs.

1024

Step 2

• Using a PH1 Philips screwdriver, remove four (9.5mm x 1.6mm) screws from the base plate.
• Remove base plate by stabilizing speaker and using plastic prying tool to pry the base plate from the speaker.

Using a PH1 Philips screwdriver, remove four (9.5mm x 1.6mm) screws from the base plate.

Remove base plate by stabilizing speaker and using plastic prying tool to pry the base plate from the speaker.

Step 3

• Place the speaker on the table with the Touch Pad facing down. This will leave you with the Port Panel exposed.
• Remove speaker grill by stabilizing speaker on a table and applying pressure to the bottom of the speaker. Slide the speaker grill up and away from the remaining endcap.

Place the speaker on the table with the Touch Pad facing down. This will leave you with the Port Panel exposed.

Remove speaker grill by stabilizing speaker on a table and applying pressure to the bottom of the speaker. Slide the speaker grill up and away from the remaining endcap.

Step 4

• Remove the two exposed (9.5mm x 1.6mm) PH1 Phillips screws on the Port Panel.
• Remove the Port Panel from the speaker body, exposing the ribbon cables.

Remove the two exposed (9.5mm x 1.6mm) PH1 Phillips screws on the Port Panel.

Remove the Port Panel from the speaker body, exposing the ribbon cables.

Step 5

• While stabilizing the Port Panel remove the two ribbon cables one at a time by pressing the locking clip down on the ribbon cable connectors and pulling the connector away from the Port Panel.

While stabilizing the Port Panel remove the two ribbon cables one at a time by pressing the locking clip down on the ribbon cable connectors and pulling the connector away from the Port Panel.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 4 other contributors 

                    Andrew Dutton                     

Member since: 02/01/2017

119 Reputation

                                      1 Guide authored                  



                       Badges:
                       6







                                                        +3 more badges                           

Team

                       UW Tacoma, Team 2-5, Rose Winter 2017                        

                                                  Member of UW Tacoma, Team 2-5, Rose Winter 2017 



                    UWT-ROSE-W17S2G5                     


                                            4 Members                     


                                            4 Guides authored