Difficulty
Moderate
Steps
7
Time Required
15 - 25 minutes
Sections
2
- Battery
- 2 steps
- Screen
- 5 steps
Flags
0
BackSamsung RC512
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Place the laptop upside down.
Place the laptop upside down.
1024
Step 2
- Locate two notches above the battery.
- Slide both battery locking notches to either side to remove the battery.
- Pull the battery out.
Locate two notches above the battery.
Slide both battery locking notches to either side to remove the battery.
Pull the battery out.
Step 3
Screen
- The Laptop should be off before removing the battery.
- Slide both battery locking notches to either side to remove the battery.
- Pull the battery out.
The Laptop should be off before removing the battery.
Step 4
- Remove the gray covers with tweezers to expose the 4mm screws.
- Using a Phillips #0 screwdriver, remove the four 4 mm Phillips #0 screws.
Remove the gray covers with tweezers to expose the 4mm screws.
Using a Phillips #0 screwdriver, remove the four 4 mm Phillips #0 screws.
Step 5
- Insert the blue plastic opening tool into the bezel and rear housing of the screen.
- Use the plastic opening tool to pop open the claps that hold the casing on the screen.
- Work your way around the sides carefully and continue this to the bottom.
- You may use your fingers to help remove the cover.
Insert the blue plastic opening tool into the bezel and rear housing of the screen.
Use the plastic opening tool to pop open the claps that hold the casing on the screen.
Work your way around the sides carefully and continue this to the bottom.
You may use your fingers to help remove the cover.
Step 6
- With the Phillips #0 screwdriver remove the six 3 mm screws, which mount the screen onto the base of the laptop.
- As you remove the last two screws, support the screen. As the screws are taken out, the screen will begin to fall forward.
With the Phillips #0 screwdriver remove the six 3 mm screws, which mount the screen onto the base of the laptop.
As you remove the last two screws, support the screen. As the screws are taken out, the screen will begin to fall forward.
Step 7
- Gently lay the LCD onto the keyboard.
- Do not separate the LCD screen and the back panel from each other. The video connector still connects the two together.
- Remove the tape that secures the video connector to the LCD screen with tweezers.
- Grasp the video connector at its base and pull it away from the LCD screen.
- The only thing holding the screen will be the clear tape causing it to come out easily.
Gently lay the LCD onto the keyboard.
Do not separate the LCD screen and the back panel from each other. The video connector still connects the two together.
Remove the tape that secures the video connector to the LCD screen with tweezers.
Grasp the video connector at its base and pull it away from the LCD screen.
The only thing holding the screen will be the clear tape causing it to come out easily.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 4 other contributors
Juri Ando
Member since: 09/15/2016
896 Reputation
8 Guides authored
Badges:
14
+11 more badges
Team
USF Tampa, Team 18-2, Blackwell Fall 2016
Member of USF Tampa, Team 18-2, Blackwell Fall 2016
USFT-BLACKWELL-F16S18G2
4 Members
8 Guides authored
