Samsung S630 Lcd Display Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          30 - 45 minutes

Sections

LCD Display
5 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

BackSamsung S630
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              LCD Display

Here is my Samsung S630. Nice little camera with just one flaw. The LCD display was broken.

Here is my Samsung S630. Nice little camera with just one flaw. The LCD display was broken.

1024

Step 2

Remove the two screws on the left side.
Remove the two on the right side.
Remove the four screws on the bottom. All eight screws are the same, so no need to ensure proper position when reassembling.

Remove the two screws on the left side.

Remove the two on the right side.

Remove the four screws on the bottom. All eight screws are the same, so no need to ensure proper position when reassembling.

Step 3

Open the battery cover and split the housing carefully. Start at the battery compartment and work your way around it. You can use an opening tool or your fingernails. Also make sure to open the USB port cover.

Open the battery cover and split the housing carefully. Start at the battery compartment and work your way around it. You can use an opening tool or your fingernails. Also make sure to open the USB port cover.

Step 4

You now look directly onto the LCD.
Gently move the LCD out of the frame and fold it toward the bottom of the camera. Do not try to remove it. It is still attached.
Remove the four screws that hold the frame to the logic board.

You now look directly onto the LCD.

Gently move the LCD out of the frame and fold it toward the bottom of the camera. Do not try to remove it. It is still attached.

Remove the four screws that hold the frame to the logic board.

Step 5

This particular camera has some Kapton tape holding the cable to the logic board. Gently remove it from the board only.
Open the locking tab on the PCB connector and remove the cable. This will separate the LCD from the board.
This is what the logic board looks like without the frame and the LCD.

This particular camera has some Kapton tape holding the cable to the logic board. Gently remove it from the board only.

Open the locking tab on the PCB connector and remove the cable. This will separate the LCD from the board.

This is what the logic board looks like without the frame and the LCD.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 1 other contributor

                    oldturkey03

Member since: 09/29/2010

722,317 Reputation

                                      109 Guides authored                  



                       Badges:
                       53







                                                        +50 more badges

Team

                       Global Fixers                        

                                                  Member of Global Fixers 



                    Community                     


                                            22 Members                     


                                            240 Guides authored

Member-Contributed Guide#

Introduction#

What you need#

Team#

Member-Contributed Guide

Introduction

What you need

Team