Difficulty
Difficult
Steps
7
Time Required
30 minutes
Sections
1
- Rubber Door
- 7 steps
Flags
0
BackSamsung S85
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Rubber Door
- Remove 4 screws from bottom of camera
- Remove 2 screws from side of camera
- Remove 2 screws from side of camera
- Place Screws on magnetic surface or location where they will not roll away
Remove 4 screws from bottom of camera
Remove 2 screws from side of camera
Place Screws on magnetic surface or location where they will not roll away
1024
Step 2
- Squeeze area noted by blue square and pull outside shell apart from remaining camera.
Squeeze area noted by blue square and pull outside shell apart from remaining camera.
Step 3
- Remove 6 screws identified by red circles
- Remove 3 screws identified by orange circles
Remove 6 screws identified by red circles
Remove 3 screws identified by orange circles
Step 4
- Gently remove orange circuit ribbon identified by red square
- Gently remove narrow orange circuit ribbon identified by blue square
Gently remove orange circuit ribbon identified by red square
Gently remove narrow orange circuit ribbon identified by blue square
Step 5
- Be very cautious when using a soldering iron (they are on average 300 F)
- Using a soldering iron, remove solder from wire identified by red circle
- Using a soldering iron, remove solder from black and red wire identified by orange circle
- Using a soldering iron, remove solder from wire identified by yellow circle
Be very cautious when using a soldering iron (they are on average 300 F)
Using a soldering iron, remove solder from wire identified by red circle
Using a soldering iron, remove solder from black and red wire identified by orange circle
Using a soldering iron, remove solder from wire identified by yellow circle
Step 6
- Using soldering iron, melt away solder and warm up metal located at top of circuit board as shown in picture
- Repeat step two to three times until board feels flexible to bend
- Slowly bend circuit board upwards (towards power button) until at 90 degree angle with remaining part of camera.
Using soldering iron, melt away solder and warm up metal located at top of circuit board as shown in picture
Repeat step two to three times until board feels flexible to bend
Slowly bend circuit board upwards (towards power button) until at 90 degree angle with remaining part of camera.
Step 7
- Remove black rubber door located on side of camera closest to lens using tweezers.
- Be careful not to bend or tear the rubber when pulling out with tweezers as it may become difficult to put back in
Remove black rubber door located on side of camera closest to lens using tweezers.
Be careful not to bend or tear the rubber when pulling out with tweezers as it may become difficult to put back in
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Avinash Salgam
Member since: 02/16/2014
597 Reputation
5 Guides authored
Badges:
7
+4 more badges
Team
University of Illinois Urbana-Champaign, Team 1-4, Scrogum Spring 2014
Member of University of Illinois Urbana-Champaign, Team 1-4, Scrogum Spring 2014
UICU-SCROGUM-S14S1G4
4 Members
10 Guides authored
