Difficulty

Moderate

Steps

6

Time Required

                          15 minutes

Sections

2

  • Cover
  • 4 steps
  • Screen
  • 2 steps

Flags

0

  • BackSamsung SCV-VLUUST50

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Cover
  • Unscrew all visible screws indicated by red circles with a #00 Phillips driver.
  • Slide memory card cover and unscrew hidden screw underneath with a #00 Phillips driver.

Unscrew all visible screws indicated by red circles with a #00 Phillips driver.

Slide memory card cover and unscrew hidden screw underneath with a #00 Phillips driver.

1024

Step 2

  • Remove the flat side panel by applying gentle pressure toward the bottom of the camera.
  • Remove the corner panel by applying pressure away from the shutter button.
  • The memory card cover will come off with the corner panel.
  • Remove the top panel by applying gentle pressure away from the shutter button.

Remove the flat side panel by applying gentle pressure toward the bottom of the camera.

Remove the corner panel by applying pressure away from the shutter button.

The memory card cover will come off with the corner panel.

Remove the top panel by applying gentle pressure away from the shutter button.

Step 3

  • Remove screws beneath the top panel indicated by red circles with a #00 Phillips driver.

Remove screws beneath the top panel indicated by red circles with a #00 Phillips driver.

Step 4

  • Remove the front and back covers by pulling them straight apart.

Remove the front and back covers by pulling them straight apart.

Step 5

              Screen
  • Open the ribbon connector with your fingernail.
  • Pull the ribbon out of the connection.

Open the ribbon connector with your fingernail.

Pull the ribbon out of the connection.

Step 6

  • Pull the ribbon connected to the screen out from behind the button circuitry on the rear of the camera.
  • Feed the new screen’s ribbon through the same slot it came out of.

Pull the ribbon connected to the screen out from behind the button circuitry on the rear of the camera.

Feed the new screen’s ribbon through the same slot it came out of.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Evert Jordan

Member since: 02/08/2018

287 Reputation

                                      2 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       University of North Texas, Team S6-G2, Thomas Spring 2018                        

                                                  Member of University of North Texas, Team S6-G2, Thomas Spring 2018 



                    UNT-THOMAS-S18S6G2                     


                                            4 Members                     


                                            12 Guides authored