Difficulty
Difficult
Steps
6
Time Required
45 minutes
Sections
1
- LCD Screen
- 6 steps
Flags
0
BackSamsung Series 5 UltraTouch NP540U3C
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Remove the Touchscreen
- Before starting, make sure the device is powered off and unplugged to prevent electrocution.
- Using a sharp object, pry the screen away from the back cover. Make sure to pry over the rubber rather than underneath as this can cause screws to break out.
- This step is difficult! See if a friend will help you take the cover off as it is easier with two sets of hands pulling.
Before starting, make sure the device is powered off and unplugged to prevent electrocution.
Using a sharp object, pry the screen away from the back cover. Make sure to pry over the rubber rather than underneath as this can cause screws to break out.
This step is difficult! See if a friend will help you take the cover off as it is easier with two sets of hands pulling.
1024
Step 2
Disconnect the Touchscreen
- There is a small, skinny wire leading from the bottom of the touchscreen to the joint of the laptop. Remove carefully with tweezers.
There is a small, skinny wire leading from the bottom of the touchscreen to the joint of the laptop. Remove carefully with tweezers.
Step 3
Remove the Screen's Frame
- Remove the frame by unscrewing the two 3.7 mm screws at the top.
Remove the frame by unscrewing the two 3.7 mm screws at the top.
Step 4
Unscrew the Screen
- Unscrew the six 3.7 mm screws holding the screen in place.
Unscrew the six 3.7 mm screws holding the screen in place.
Step 5
Unplug the Video Connection
- Pull the screen down and remove the tape over the video connection.
- Remove the video cables from the screen. This is easiest with tweezers.
Pull the screen down and remove the tape over the video connection.
Remove the video cables from the screen. This is easiest with tweezers.
Step 6
Remove the Old Screen
- Remove the old screen from its location.
Remove the old screen from its location.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
8 other people completed this guide.
Author
with 4 other contributors
Timothy
Member since: 01/30/2015
1,564 Reputation
5 Guides authored
Badges:
12
+9 more badges
Team
USF Tampa, Team 16-3, Watkins Winter 2015
Member of USF Tampa, Team 16-3, Watkins Winter 2015
USFT-WATKINS-W15S16G3
4 Members
5 Guides authored
Maud Attrill - Jul 12, 2015
Reply
In order to access the screens 2 lower screws, using a plastic tool unclip the plastic hinge at its join.There are a few further clips at the far edges. The plastic cover can now be removed and will reveal the lcd and touchscreen connectors. This is best done BEFORE attempting to loosen the touchscreen. The top screen frame does not have to be removed in order to remove the lcd.
Guide proved useful when I needed to change the lcd cable due to hinge abrasion damage.
vibe builds roblox - Aug 27, 2020
Is it possible to remove the plastic hinge to access the lcd connectors without taking the lcd screen off? I have an issue with intermittant screen graphics and think its a connector problem but can;t get to it
Roman - Nov 12, 2018
Reply
Hi,
Where to buy screen for this laptop.
Samsung 13.3” Series 5 Ultrabook
NP540U3C-A02AU
Sr No: HYTQ91DCA00002B
