Samsung Tl220 Af Assist Lamp Replacement Repair Guide

Difficulty

Moderate

Steps

7

Time Required

Suggest a time??

Sections

1

• Light Bulb
• 7 steps

Flags

3

Markup Mishap

This guide needs better markups. Help out by correcting or making some markup annotations.

Slice and Dice

The steps in this guide should be split up and made into a series of prerequisite guides.

Better Introduction

Improve this guide by completing or revising its introduction.

• BackSamsung TL220

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

What you need

Step 1

              Light Bulb               

• Begin with unscrewing the seven outside shell 4 mm Philip screws with the Philips screw driver.
• Now carefully pry open the back casing with the ifixit plastic opening tool.

Begin with unscrewing the seven outside shell 4 mm Philip screws with the Philips screw driver.

Now carefully pry open the back casing with the ifixit plastic opening tool.

1024

Step 2

• Now that you have the back casing off, gently remove the LCD screen up and to lay on top of the table to the right.
• Next unscrew with the same screw driver, the 4 mm Philip screws on the back panel.

Now that you have the back casing off, gently remove the LCD screen up and to lay on top of the table to the right.

Next unscrew with the same screw driver, the 4 mm Philip screws on the back panel.

Step 3

• Unclip the four connecters that hold down the orange copper film strips with the plastic opening tool.
• Then carefully pull out the three film strips with the ifixit tweezers.

Unclip the four connecters that hold down the orange copper film strips with the plastic opening tool.

Then carefully pull out the three film strips with the ifixit tweezers.

Step 4

• Remove the 4 mm Philip screws located above the center film strip with the Philip screw driver. This will allow the top frame to come loose to take off.

Remove the 4 mm Philip screws located above the center film strip with the Philip screw driver. This will allow the top frame to come loose to take off.

Step 5

• Then pull the black claw located at the bottom right of the camera, to the right with the plastic opening tool. This holds the main plate down.

Then pull the black claw located at the bottom right of the camera, to the right with the plastic opening tool. This holds the main plate down.

Step 6

• Slowly lift with your fingers, the top frame of the camera up, disconnecting it from the main piece.

Slowly lift with your fingers, the top frame of the camera up, disconnecting it from the main piece.

Step 7

• This piece disconnected exposes the light bulb that you can change out at this point in the guide.

This piece disconnected exposes the light bulb that you can change out at this point in the guide.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 2 other contributors 

                    chelsa                     

Member since: 03/03/2015

358 Reputation

                                      3 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges                           

Team

                       3 Tech Girls                        

                                                  Member of 3 Tech Girls 



                    Community                     


                                            2 Members                     


                                            4 Guides authored