Difficulty

Moderate

Steps

6

Time Required

                          15 - 20 minutes

Sections

1

  • Battery Spring Replacement
  • 6 steps

Flags

2

Markup Mishap

This guide needs better markups. Help out by correcting or making some markup annotations.

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackSamsung TL220

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Battery Spring Replacement
  • Begin by unscrewing all seven 4 mm phillip’s screws located on the outside of the camera.
  • Using the plastic opening tool carefully pry open the camera, lifting the back casing off.

Begin by unscrewing all seven 4 mm phillip’s screws located on the outside of the camera.

Using the plastic opening tool carefully pry open the camera, lifting the back casing off.

1024

Step 2

  • Now that you have the back casing off, gently move the LCD screen from the camera to the right and lay it facing down on the table.
  • Next unscrew the three 4 mm Philips screws on the back panel with the same screw driver.

Now that you have the back casing off, gently move the LCD screen from the camera to the right and lay it facing down on the table.

Next unscrew the three 4 mm Philips screws on the back panel with the same screw driver.

Step 3

  • Unclip the four connectors with the plastic opening tool which holds down the orange film strips.
  • Gently with the tweezers remove the four orange film strips from the connectors.

Unclip the four connectors with the plastic opening tool which holds down the orange film strips.

Gently with the tweezers remove the four orange film strips from the connectors.

Step 4

  • Once the orange film strips have been released from the connectors, unscrew the Phillips 4 mm silver screw which holds down the top of the camera’s frame.
  • With your fingers gently push up the camera’s top frame. Once the camera’s top frame is off you can than gently remove the camera’s front casing off, as well.

Once the orange film strips have been released from the connectors, unscrew the Phillips 4 mm silver screw which holds down the top of the camera’s frame.

With your fingers gently push up the camera’s top frame. Once the camera’s top frame is off you can than gently remove the camera’s front casing off, as well.

Step 5

  • Flip the entire camera over so that the lenses are facing upward with the LCD screen showing to the side.
  • Now remove the silver case, seen demonstrated in the picture.

Flip the entire camera over so that the lenses are facing upward with the LCD screen showing to the side.

Now remove the silver case, seen demonstrated in the picture.

Step 6

  • After all the parts are disassembled, you will reach the spring part of the camera.

After all the parts are disassembled, you will reach the spring part of the camera.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 3 other contributors 


                    chelsa

Member since: 03/03/2015

358 Reputation

                                      3 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       3 Tech Girls                        

                                                  Member of 3 Tech Girls 



                    Community                     


                                            2 Members                     


                                            4 Guides authored