Difficulty

Easy

Steps

4

Time Required

                          15 minutes

Sections

1

  • Low Voltage Display Signal Board
  • 4 steps

Flags

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackSamsung U28E510

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Low Voltage Display Signal Board
  • Start by removing the screen bezel.
  • Use a pair of spudgers to pry between the bezel and the rest of the monitor.
  • Ideally use plastic tools as this step could damage the edges of the screencover.
  • lay monitor on its back and pull off screen cover.

Start by removing the screen bezel.

Use a pair of spudgers to pry between the bezel and the rest of the monitor.

Ideally use plastic tools as this step could damage the edges of the screencover.

lay monitor on its back and pull off screen cover.

1024

Step 2

  • Flip the monitor over so that it is face down.
  • Remove the single screw in the middle using a #2 Phillips screwdriver.
  • Remove the backing to reveal the Low Voltage Display Signal Board.

Flip the monitor over so that it is face down.

Remove the single screw in the middle using a #2 Phillips screwdriver.

Remove the backing to reveal the Low Voltage Display Signal Board.

Step 3

  • Remove the 4 holding screws using a #0 Phillips screwdriver.
  • Lift the cover to expose the LVDS Board while taking care to prevent removal of the white fogged plastic cover. This plastic cover keeps the wire ribbons safe from accidental damage.

Remove the 4 holding screws using a #0 Phillips screwdriver.

Lift the cover to expose the LVDS Board while taking care to prevent removal of the white fogged plastic cover. This plastic cover keeps the wire ribbons safe from accidental damage.

Step 4

  • Disconnect the input signal ribbon cable from the top of the board.
  • Disconnect the output signal ribbon cables by using a plastic sprudger to lift the connection lock.
  • Remove and replace the LVDS Board.

Disconnect the input signal ribbon cable from the top of the board.

Disconnect the output signal ribbon cables by using a plastic sprudger to lift the connection lock.

Remove and replace the LVDS Board.

To reassemble your device, follow these instructions in reverse order. Ensure the bezel completely snaps in place all around the monitor.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Raymundo Calderon-Robles

Member since: 01/22/2018

285 Reputation

                                      1 Guide authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       Cal Poly, Team S11-G1, Banghart Winter 2018                        

                                                  Member of Cal Poly, Team S11-G1, Banghart Winter 2018 



                    CPSU-BANGHART-W18S11G1                     


                                            4 Members                     


                                            3 Guides authored