Samsung U28E510 Motherboard Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          15 minutes

Sections

Motherboard
4 steps

Flags

BackSamsung U28E510
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Motherboard

Start by removing the screen bezel.
Use a pair of spudgers to pry between the cover and the rest of the monitor.
Ideally use plastic tools as this step could damage the edges of the screencover.
Lay monitor on its back and pull off screen cover.

Start by removing the screen bezel.

Use a pair of spudgers to pry between the cover and the rest of the monitor.

Ideally use plastic tools as this step could damage the edges of the screencover.

Lay monitor on its back and pull off screen cover.

1024

Step 2

Flip the monitor over so that it is facedown.
Remove the single screw in the middle using a #2 Phillips screwdriver.
Remove backing to reveal signal/power board in center.

Flip the monitor over so that it is facedown.

Remove the single screw in the middle using a #2 Phillips screwdriver.

Remove backing to reveal signal/power board in center.

Step 3

Ensure to grip the connection plugs when removing wires to prevent damage to wires.
Unplug wires connected to supply (one on the left and one on right).
Disconnect the signal ribbon cable.
Pull the motherboard shield off—it’s adhered in place by tape, so some force may be needed.

Ensure to grip the connection plugs when removing wires to prevent damage to wires.

Unplug wires connected to supply (one on the left and one on right).

Disconnect the signal ribbon cable.

Pull the motherboard shield off—it’s adhered in place by tape, so some force may be needed.

Step 4

Lay piece upside down.
Use a #2 Phillips screwdriver to remove the two screws that secure the motherboard.
Lift the motherboard out of the metal shield.

Lay piece upside down.

Use a #2 Phillips screwdriver to remove the two screws that secure the motherboard.

Lift the motherboard out of the metal shield.

To reassemble your device, follow these instructions in reverse order. Ensure the bezel snaps in place all around monitor.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 2 other contributors

                    Melina

Member since: 01/22/2018

154 Reputation

                                      1 Guide authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       Cal Poly, Team S11-G1, Banghart Winter 2018                        

                                                  Member of Cal Poly, Team S11-G1, Banghart Winter 2018 



                    CPSU-BANGHART-W18S11G1                     


                                            4 Members                     


                                            3 Guides authored

Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Introduction

What you need

Team