Difficulty

Easy

Steps

8

Time Required

                          10 - 15 minutes

Sections

2

  • Outer Shell
  • 4 steps
  • Disc Drive
  • 4 steps

Flags

0

  • BackSamsung UBD-KM85C

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Outer Shell
  • On the back side of the unit, remove the three 8.1mm screws marked with a Phillips #1 screwdriver.

On the back side of the unit, remove the three 8.1mm screws marked with a Phillips #1 screwdriver.

1024

Step 2

  • From the back, lift the case upwards away from the unit then forwards, releasing the prongs on the front.

From the back, lift the case upwards away from the unit then forwards, releasing the prongs on the front.

Step 3

  • There is one group of wires located towards the front of the case and attached directly to the motherboard and the case. Using two fingers in a pinching motion, release the wire from the clip and disconnect it.

There is one group of wires located towards the front of the case and attached directly to the motherboard and the case. Using two fingers in a pinching motion, release the wire from the clip and disconnect it.

Step 4

  • Remove the cover from the device.

Remove the cover from the device.

Step 5

              Disc Drive
  • The disk drive is the large metallic rectangular unit that occupies a third of the space inside the unit.

The disk drive is the large metallic rectangular unit that occupies a third of the space inside the unit.

Step 6

  • The disk drive has four 6.5mm screws located near each of its corners that hold it onto the frame. Use a #1 Phillips head screwdriver to remove these screws.

The disk drive has four 6.5mm screws located near each of its corners that hold it onto the frame. Use a #1 Phillips head screwdriver to remove these screws.

Step 7

  • The disk drive has two connections to the motherboard that can be disconnected by pulling on the blue plastic tabs.

The disk drive has two connections to the motherboard that can be disconnected by pulling on the blue plastic tabs.

Step 8

  • Once the connections are unplugged and the screws are removed, the disk drive can be lifted out. The previous steps can be done in the reverse order to replace the part.

Once the connections are unplugged and the screws are removed, the disk drive can be lifted out. The previous steps can be done in the reverse order to replace the part.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors 


                    James Edwards

Member since: 02/01/2018

627 Reputation

                                      5 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       Baylor, Team S2-G1, Johnson Spring 2018                        

                                                  Member of Baylor, Team S2-G1, Johnson Spring 2018 



                    BU-JOHNSON-S18S2G1                     


                                            3 Members                     


                                            6 Guides authored