Difficulty

Easy

Steps

7

Time Required

                          10 - 15 minutes

Sections

2

  • Outer Shell
  • 4 steps
  • WiFi Module
  • 3 steps

Flags

0

  • BackSamsung UBD-KM85C

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Outer Shell
  • On the back side of the unit, remove the three 8.1mm screws marked with a Phillips #1 screwdriver.

On the back side of the unit, remove the three 8.1mm screws marked with a Phillips #1 screwdriver.

1024

Step 2

  • From the back, lift the case upwards away from the unit then forwards, releasing the prongs on the front.

From the back, lift the case upwards away from the unit then forwards, releasing the prongs on the front.

Step 3

  • There is one group of wires located towards the front of the case and attached directly to the motherboard and the case. Using two fingers in a pinching motion, release the wire from the clip and disconnect it.

There is one group of wires located towards the front of the case and attached directly to the motherboard and the case. Using two fingers in a pinching motion, release the wire from the clip and disconnect it.

Step 4

  • Remove the cover from the device.

Remove the cover from the device.

Step 5

              WiFi Module
  • The wifi module is clipped into place in the corner of the device. There are no screws or adhesives holding it down.

The wifi module is clipped into place in the corner of the device. There are no screws or adhesives holding it down.

Step 6

  • There is one wire plugged into the Wi-Fi module that has to be removed in order to allow the range of motion to remove the module. Simply pinch the white plastic end of the wire and pull it out.

There is one wire plugged into the Wi-Fi module that has to be removed in order to allow the range of motion to remove the module. Simply pinch the white plastic end of the wire and pull it out.

Step 7

  • Pull on the module from the sides and be sure not to pull on the stand that is screwed into the frame. The Wi-Fi module can then be pulled out of the clips and off the stand.

Pull on the module from the sides and be sure not to pull on the stand that is screwed into the frame. The Wi-Fi module can then be pulled out of the clips and off the stand.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors 


                    James Edwards

Member since: 02/01/2018

627 Reputation

                                      5 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       Baylor, Team S2-G1, Johnson Spring 2018                        

                                                  Member of Baylor, Team S2-G1, Johnson Spring 2018 



                    BU-JOHNSON-S18S2G1                     


                                            3 Members                     


                                            6 Guides authored