Samsung Wb1100F Lcd Screen Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          20 minutes

Sections

LCD Screen Cover
2 steps
LCD Screen
2 steps

Flags

Needs More Images

A few more images would make this guide’s procedures crystal clear.

BackSamsung WB1100F
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              LCD Screen Cover

Remove six 1.2 mm Phillips #00 screws connected to the tripod dock and adjacent screws.
Remove six 1.2 mm Phillips #00 screws from the side of the camera.

Remove six 1.2 mm Phillips #00 screws connected to the tripod dock and adjacent screws.

Remove six 1.2 mm Phillips #00 screws from the side of the camera.

1024

Step 2

Use a plastic opening tool or spudger if available.
Using the flat end of a spudger, loosen the connection between the back panel and the device. Remove the back panel using your hands.

Use a plastic opening tool or spudger if available.

Using the flat end of a spudger, loosen the connection between the back panel and the device. Remove the back panel using your hands.

Step 3

              LCD Screen

Remove four 1.2 mm Phillips #1 screws connected to the LCD screen.

Remove four 1.2 mm Phillips #1 screws connected to the LCD screen.

Step 4

Flip the LCD screen over to reveal the display cable.
Use the tip of a spudger or your fingernail to flip up the small retaining flap on the display cable ZIF connector.
Be sure you are prying up on the hinged retaining flap, not the connector itself.
Using a pair of tweezers, remove the ribbon cable from its socket on the motherboard.
The white line on this ribbon cable marks the edge of the connection area. To reinstall, insert the cable into the connector up to this line, and then close the retaining flap. If the cable doesn’t insert easily up to (or very near to) this line, it’s probably misaligned and needs to be gently removed and repositioned.

Flip the LCD screen over to reveal the display cable.

Use the tip of a spudger or your fingernail to flip up the small retaining flap on the display cable ZIF connector.

Be sure you are prying up on the hinged retaining flap, not the connector itself.

Using a pair of tweezers, remove the ribbon cable from its socket on the motherboard.

The white line on this ribbon cable marks the edge of the connection area. To reinstall, insert the cable into the connector up to this line, and then close the retaining flap. If the cable doesn’t insert easily up to (or very near to) this line, it’s probably misaligned and needs to be gently removed and repositioned.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors

                    Jesse Lindsey

Member since: 05/13/2016

581 Reputation

                                      5 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       Metro State, Team 1-1, Carpenter SU 2016                        

                                                  Member of Metro State, Team 1-1, Carpenter SU 2016 



                    MSU-CARPENTER-SU16S1G1                     


                                            3 Members                     


                                            5 Guides authored

Needs More Images#

Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Needs More Images

Introduction

What you need

Team