Samsung Wb2100 Back Cover Assembly Replacement Repair Guide

Difficulty

Moderate

Steps

2

Time Required

                          10 minutes            

Sections

1

• Back Cover Assembly
• 2 steps

Flags

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Needs More Images

A few more images would make this guide’s procedures crystal clear.

• BackSamsung WB2100

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Back Cover Assembly               

• Remove the 7 screws on the outside of the camera
• Two 5 mm PH000 screws on the right side of the camera body
• Four 3mm PH000 screws on the bottom and the left side of the camera body.
• Use the plastic spundger to push the back casing out. Start from the right side and work your way clockwise around the case.
• The HDMI / AV tab might fall out. this is supposed to happen as it is not screwed into place in the back casing.

Remove the 7 screws on the outside of the camera

Two 5 mm PH000 screws on the right side of the camera body

Four 3mm PH000 screws on the bottom and the left side of the camera body.

Use the plastic spundger to push the back casing out. Start from the right side and work your way clockwise around the case.

The HDMI / AV tab might fall out. this is supposed to happen as it is not screwed into place in the back casing.

1024

Step 2

• Disconnect the set of wires from the back casing to the motherboard. Do this by using the plastic spundger to flip the black tab up and the wires will pull out.
• Unscrew the four 3 mm and two silver 1 mm PH000 screw from the green logic board

Disconnect the set of wires from the back casing to the motherboard. Do this by using the plastic spundger to flip the black tab up and the wires will pull out.

Unscrew the four 3 mm and two silver 1 mm PH000 screw from the green logic board

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 2 other contributors 

                    Mason Ricks                     

Member since: 01/20/2016

282 Reputation

                                      2 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges                           

Team

                       USF Tampa, Team 15-3, Remmell Spring 2016                        

                                                  Member of USF Tampa, Team 15-3, Remmell Spring 2016 



                    USFT-REMMELL-S16S15G3                     


                                            4 Members                     


                                            6 Guides authored