Difficulty

Moderate

Steps

10

Time Required

                          15 minutes

Sections

3

  • Battery
  • 4 steps
  • Face-plate
  • 3 steps
  • Flash Option Button
  • 3 steps

Flags

0

  • BackSamsung WB2200F

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Place the camera upside down on a hard surface such as a table. Make sure that the battery compartment is visible.

Place the camera upside down on a hard surface such as a table. Make sure that the battery compartment is visible.

1024

Step 2

  • Twist the nob counter-clockwise while pushing cover to the left. Then pull the cover up to reveal the battery.

Twist the nob counter-clockwise while pushing cover to the left. Then pull the cover up to reveal the battery.

Step 3

  • Slide the blue tab to the right to release the battery.

Slide the blue tab to the right to release the battery.

Step 4

  • Carefully slide the battery out of the camera. It can then be replaced with a new battery.

Carefully slide the battery out of the camera. It can then be replaced with a new battery.

Step 5

              Face-plate
  • Remove the 6mm screws located on the bottom and sides of the camera using the using the screw driver with the JIS size 000 head.

Remove the 6mm screws located on the bottom and sides of the camera using the using the screw driver with the JIS size 000 head.

Step 6

  • Remove the two 6mm screws located underneath the battery cover using the same screw driver with the JIS size 000 head.

Remove the two 6mm screws located underneath the battery cover using the same screw driver with the JIS size 000 head.

Step 7

  • Carefully pry the face-plate away from the body of the camera, starting from the battery compartment. It should come off without too much trouble, although it may require force.
  • Make sure to not damage any of the electronic components of the camera

Carefully pry the face-plate away from the body of the camera, starting from the battery compartment. It should come off without too much trouble, although it may require force.

Make sure to not damage any of the electronic components of the camera

Step 8

              Flash Option Button
  • Looking at the back of the exposed face plate, remove the four 5mm screws, that hold down the metal cover, using the screw driver with the JIS size 000 head.

Looking at the back of the exposed face plate, remove the four 5mm screws, that hold down the metal cover, using the screw driver with the JIS size 000 head.

Step 9

  • Gently lift off the metal cover.

Gently lift off the metal cover.

Step 10

  • Clean out any dust or debris from the button interface.
  • Replace faulty button.

Clean out any dust or debris from the button interface.

Replace faulty button.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Rachelle

Member since: 03/08/2016

213 Reputation

                                      2 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       UMass Dartmouth, Team 5-4, Landers Spring 2016                        

                                                  Member of UMass Dartmouth, Team 5-4, Landers Spring 2016 



                    UMASSD-LANDERS-S16S5G4                     


                                            3 Members                     


                                            12 Guides authored