Difficulty
Moderate
Steps
5
Time Required
10 minutes
Sections
1
- Screen
- 5 steps
Flags
0
BackSamsung WB850F
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Screen
- First remove the battery and SD Card
- Then use the screwdriver to remove the 6 screws that need to be removed to take off the outer case.
- 2 screws are located on the bottom.
- 2 screws are located on the left side (near the HDMI port).
- 2 screws are located on the right side (opposite side of the HDMI port).
First remove the battery and SD Card
Then use the screwdriver to remove the 6 screws that need to be removed to take off the outer case.
2 screws are located on the bottom.
2 screws are located on the left side (near the HDMI port).
2 screws are located on the right side (opposite side of the HDMI port).
1024
Step 2
- Once the screws are removed, use the blue opening tool to open the back case from the sides - it should come off easily.
Once the screws are removed, use the blue opening tool to open the back case from the sides - it should come off easily.
Step 3
- Use the screwdriver to remove the small silver screw holding down the control panel (located on the bottom right next to the screen).
- Use the blue opening tool to lift up the control panel from where the screw was just removed.
Use the screwdriver to remove the small silver screw holding down the control panel (located on the bottom right next to the screen).
Use the blue opening tool to lift up the control panel from where the screw was just removed.
Step 4
- Use the tweezers to gently pull the yellow control board ribbon cable out of its connector.
- The display cable stands straight up and pops out easily. Pull up on it to remove the screen from the camera.
Use the tweezers to gently pull the yellow control board ribbon cable out of its connector.
The display cable stands straight up and pops out easily. Pull up on it to remove the screen from the camera.
Step 5
- Connect the new screen by gently pressing the display cable on to its connector (on the motherboard).
- When reinserting the control board, make sure the top of the control board is under the lip before screwing it in place.
Connect the new screen by gently pressing the display cable on to its connector (on the motherboard).
When reinserting the control board, make sure the top of the control board is under the lip before screwing it in place.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 6 other contributors
Jousling Vazquez
Member since: 02/08/2016
431 Reputation
4 Guides authored
Badges:
9
+6 more badges
Team
USF Tampa, Team 12-4, Eyestone Spring 2016
Member of USF Tampa, Team 12-4, Eyestone Spring 2016
USFT-EYESTONE-S16S12G4
4 Members
8 Guides authored
Ian Blyth - Sep 30, 2021
Reply
I previously mentioned that I had a sticky substance seeping from my camera. I spent quite a long time, using acetone to remove this fluid stuff from the LCD and the clear screen which was stuck to the LCD. It was not an easy task because of the quick evaporation of the acetone. Now, must I stick the LCD and the part/clear lens together? If so, with what glue? The second part to my question is that there was a second plate (?) with a rubbery surface on one side and I did not notice which side faces the lens because it fell out before I noticed it, rubber or plain metal? Any help will be appreciated. :-(
Hon Fah Cheung - Dec 3, 2022
Is it normal from such a renowned company? I even got some instability in installed programs.
