Difficulty
Moderate
Steps
5
Time Required
5 - 10 minutes
Sections
2
- Battery
- 2 steps
- Back Casing
- 3 steps
Flags
0
BackSanyo Katana
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Place thumb on the tab located at the back of the phone and slide button towards your hand and away from phone.
- While holding down the button, pull cover off with other hand.
Place thumb on the tab located at the back of the phone and slide button towards your hand and away from phone.
While holding down the button, pull cover off with other hand.
1024
Step 2
- Use fingers to grip the battery and remove it from the phone.
Use fingers to grip the battery and remove it from the phone.
Step 3
Back Casing
- Using a spudger, remove the four rubber coverings on the lower back plate.
Using a spudger, remove the four rubber coverings on the lower back plate.
Step 4
- Using a Tri-wing Y0 screwdriver, remove the four 4.4mm screws securing the back plate.
Using a Tri-wing Y0 screwdriver, remove the four 4.4mm screws securing the back plate.
Step 5
- Remove the lower back cover to reveal part of the motherboard and the circular speaker housed in the back cover plate.
Remove the lower back cover to reveal part of the motherboard and the circular speaker housed in the back cover plate.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 5 other contributors
Preston
Member since: 03/11/2013
216 Reputation
5 Guides authored
Badges:
10
+7 more badges
Team
Clemson, Team 12-1, Benson Spring 2013
Member of Clemson, Team 12-1, Benson Spring 2013
CLEM-BENSON-S13S12G1
4 Members
20 Guides authored
